JBC DT20 Glass Solder-Collector for DT530 Owner's Manual
The jbc DT20 is a glass solder-collector designed for use with the DT530 desoldering iron. It is a key component of the desoldering process, allowing for efficient and clean removal of solder from electronic components. The DT20 features a replaceable filter, allowing for extended use and reduced operating costs. It also features a convenient suction tube connector that allows for easy attachment and detachment from the desoldering iron.
Advertisement
Advertisement
Advertisement
Key features
- Replaceable filter
- Suction Tube Connector
- Heat-Resistant Gripper
- Cleaning Brush
- Easy to Remove and Replace
Frequently asked questions
Hold down the tool with one hand onto the stand (1) and grasp the suction tube at the point where it meets the suction tube connector and pull upward (2).
Gently pull both the suction tube connector and the solder collector in opposite directions (3). If the solder-collector is too hot, use the heat-resistant gripper provided with the tool.
Use the cleaning brush to push the old filters out of the worn DT20 (4). Then, replace the filters, fit the rearward gasket onto the solder-collector (6), push the filters against the gasket using the cleaning brush (7), and fit the front gasket onto the DT20 (5).