rfm-3100 (dish network / bell tv)

HOW TO CONVERT
RFM-2100 (SHAW DIRECT)
TO
RFM-3100 (DISH NETWORK / BELL TV)
The RFM-2100 SHAW Direct mount comes pre-wired with 4 coax cables. This will allow for 2
SHAW PVR's. The RFM-3100 (Dish Network / Bell TV) will only use 3 coax cables. Follow this
procedure and the conversion will be complete.
Converting a RFM-2100 to a RFM-3100






Order a RFM-3100 LNB Arm Kit. It comes with LNB Arm and Dish 1000.2 Dish Pro Plus LNB.
Assemble the mount or replace the RFM-2100 LNB Arm using the RFM-3100 LNB Arm Kit.
Attach only the Green Coax cables to the Dish Network / Bell TV LNB (see picture below).
DO NOT CONNECT THE RED COAX . IT IS NOT TO BE USED.
Any one of the Green coax cables can attach to the RFM-1000/1100 controller to the connection
marked "Antenna".
Set your configurable Dip Switches to 2 up for Dish Network or 3 up for Bell TV.
Dish Network / Bell TV
Dish 1000.2 Dish Pro Plus LNB
The Dish 1000.2 Dish Pro Plus LNB has a port which is labeled "LNB IN" and is used when a
home system would like access to an additional satellite antenna which would look at a satellite other than
what the Dish 1000.2 can provide. It should not be used with the RFM-3100 system. If you connect to
this port it will not provide your system with an "output" signal.
DO NOT CONNECT A COAX TO THIS PORT