CORDLESS AIR COMPRESSOR
TYRE INFLATOR
CTAIRCCRDLA
SAFETY & WARNINGS
• Read all instructions carefully and retain this user guide for future reference.
• Improper use of this tyre inflator may result in product damage, excess heat, toxic
fumes, fire, or explosion.
• Children must not operate the tyre inflator alone.
• Do not use the tyre inflator in sunlight, high temperature or high pressure.
• Do not put the tyre inflator in water.
• Do not exposure the tyre inflator to rain or use it in or near water.
• After 10 minutes of constant use, it is recommended to turn the tyre inflator off and
allow it to cool for 30 minutes to extend its service life. If long-time operation is
unavoidable, take intermittent breaks to allow the tyre inflator cool down.
• Turn the power switch off after use.
• Store the tyre inflator indoors and away from fire.
• During operation, the tyre inflator will get warm. This is normal.
COMPONENTS
USB-C Charging Cable
Multifunctional Nozzles
OVERVIEW
Air Hose
Heat Resistant Hose
Pressure Display
Buttons
Air Hose
Light
USB-C Charging Port
USB Port
OPERATION
Charging
• Plug the USB-C end of the provided charging cable into the USB-C charging port on
the tyre inflator. Plug the USB end of the provided charging cable into a power adapter.
• The USB-A port can be used to charge devices.
Using the Tyre Inflator
1.
Connect the air hose to the inflator.
2.
Screw the air hose to the tire valve.
3.
Press the hold
for 3 seconds to
power on the inflator.
4.
Press
to wake up the screen or start
inflating.
5.
Press
different modes:
4
6.
.
Press and hold
3 seconds to
adjust the target pressure.
7.
Press + or - to increase or
decrease the target pressure.
9.
When the real pressure reaches to the target pressure, inflation will stop
automatically. Stop inflating any time by pressing . Turn off the power switch
after use.
8.
Press
to start inflating.
Inflation Mode
Sedan Car Tire
Bicycle
Motorcycle
Ball
Pre-set Pressure
1.
Press
2.
Press: + or - to increase or decrease the target pressure.
to change the pressure unit.
3.
When the pressure display stops flashing, press
4.
When the desired pressure is reached, it will stop automatically.
Mode Type
Battery Display
to start inflating.
Pressure Display
Pressure Unit
Increase Pre-set
Pressure Button
Decrease Pre-set
Pressure Button
LED Light Button
Change Mode/Change
Pressure Button
Power Button
Battery Display
Battery Mark
Description
Battery Percentage
First
Solid.
100-70%.
Second
Solid.
70-40%.
Third
Solid.
40-10%.
Fourth
Flashing.
<10%
SPECIFICATIONS
Model Material
ABS
Dimension
89 x 47.5 x 137mm
Power
50W
Voltage
7.4V
Battery Capacity
2000mAh x2
USB-A Output
5V/1A
NOTES
Need more information?
">