RIDGID 18 Volt R841150, R841151 power drill SERVICE BULLETIN

RIDGID 18 Volt R841150, R841151 power drill SERVICE BULLETIN

Below you will find brief information for power drill RIDGID 18 Volt R841150, power drill RIDGID 18 Volt R841151. This bulletin provides instructions on how to repair the tool if it has no power from the battery pack. The bulletin describes the required parts and service procedures, including how to remove and replace the variable speed switch. It also emphasizes that the battery is a nonserviceable item and should not be opened for repair.

advertisement

Assistant Bot

Need help? Our chatbot has already read the manual and is ready to assist you. Feel free to ask any questions about the device, but providing details will make the conversation more productive.

RIDGID 18 Volt R841150, RIDGID 18 Volt R841151 Service Bulletin | Manualzz

Service Level

RIDGID

One World Technologies, Inc.

MANDATORY

SERVICE BULLETIN

Product – R841150, R841151 RIDGID 18 Volt Hammer Drill

Identification – RIDGID 18 Volt 1/2” Chuck Hammer Drill – R841150 “T”

Handle design, R841151 Rear Handle design.

Condition – If the R841150 or R841151 18 Volt Hammer drill is serviced due to no power from the battery pack(s), replace the variable speed switch before operating the tool with a known good battery.

Remedy – Remove and replace the variable speed switch. Replace the battery as needed. Do not open the battery in an attempt to repair it is a nonserviceable item.

Service Components Required

1 ea. Variable Speed Switch ---------------------------- pt. # 270018090

Service Procedures

Remove the battery. Remove the T-20 torx screws in the end cap, housing and gearbox. With the data plate facing upward, remove the housing exposing the switch assembly. Rotate the switch exposing the motor leads.

Using a solder gun, remove the motor “+” lead (red wire) from the switch and solder it to the new switch routing the wire through the eyelet from the back side of the terminal. Duplicate the process with the motor “-“ lead

(black wire). Reposition the switch and battery terminal into the housing and reassemble ensuring the wiring harness is routed through the guides of the housing. Note: The white insulator must protect the wiring harness

between the motor and the housing. A replacement insulator is supplied

if needed. Reattach the end cap, and housing test full operation of the product.

Submit warranty claim using warranty code -------- R5051SWH0904

Warranty claim compensation -------------------------------- $25.00

For technical assistance contact RIDGID technical support at 866-539-1710

Page 1 of 1 G. Pena R5051SVB1 - 090904

advertisement

Key Features

  • 18 Volt Hammer Drill
  • Variable Speed Switch
  • T-20 Torx screws
  • Solder Gun
  • Battery Pack

Frequently Answers and Questions

What is the issue with the R841150 or R841151 18 Volt Hammer drill?
The tool may experience a lack of power from the battery pack(s).
How do I repair the R841150 or R841151 18 Volt Hammer drill?
You need to replace the variable speed switch. The battery is a nonserviceable item and should not be opened for repair.
What parts are needed to repair the R841150 or R841151 18 Volt Hammer drill?
You will need one variable speed switch with part number 270018090.
What is the warranty claim compensation for repairing the R841150 or R841151 18 Volt Hammer drill?
The warranty claim compensation is $25.00.

Related manuals

Download PDF

advertisement