Optional Spring Box Mount Bracket (60897)

Optional Spring Box Mount Bracket (60897)
SPRING BOX MOUNT BRACKET
INSTRUCTIONS
Note to installer: This bracket is intended as an alternative mounting point if needed when installing
spring boxes on trailers with exterior structural ribs.
LOCK NUTS (2X)
TRAILER RIB
SPRING BOX
SPECIAL BRACKET
3/8” x 1” THREAD
CUTTING BOLT (2X)
ALLEN BOLTS
1) Position bracket on solid mounting surface of box wall (between ribs) so it fills gap between wall
and spring box.
2) Mark bolting locations. Drill 5/16 holes. Fasten bracket to box wall with 3/8 x 1” thread cutting hex
head bolt (2x). IMPORTANT: If mounting bracket to thin wall sheet metal, use extra nuts, flat washer
and lock washer (Included in Kit) on back side of wall to secure bracket
3) Mount spring box to bracket using allen head bolts and lock nuts as shown. Then continue
mounting reamainder of spring box as specified in spring box installation section of the
owner’s manual.
Part No. 60897_
©2010 Agri-Cover, Inc. All Rights Reserved.
051410
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement