DAC-457000 Digital-Analog Circuits Lab 1. SOLDERLESS BREADBOARD: AD-22

DAC-457000 Digital-Analog Circuits Lab  1. SOLDERLESS BREADBOARD: AD-22
DAC-457000 : Digital-Analog Circuits Lab
Specifications:
1. SOLDERLESS BREADBOARD: AD-22
Interconnected with 2712 tie points nickel plated contact, fitted all DIP sizes and all components with lead
and solid wire AWG #22-30 (0.3 ~ 0.8mm). It can be changed and replaced for different purpose and can be
connected with demonstration panel. Therefore, it is very convenient for both teachers and students.
2. DC POWER SUPPLY:
(A) Fixed DC output: +5V, IAMP.
(B) Fixed DC output: -5V, 300m AMP.
(C) Variable DC output: 0V to + 15V, 1 AMP.
(D) Variable DC output: 0V to - 15V, 1 AMP.
3. POTENTIOMETERS:
(A) Variable resistor VR1 =1 K (B),
(B) Variable resistor VR2 = 100K (B)
4. FUNCTION GENERATOR:
(A) Frequency range:1 Hz ~ 10Hz, 10Hz ~ 100HZ, 100HZ ~ 1 KHz, 1 kHz ~ 10KHZ, 10KHz ~ 100KHz
(B)Amplitude: Sinewave output: 0 ~ 8 Vpp variable
Triangle wave output: 0 ~ 6 Vpp variable
Square wave output 0 ~ 8 Vpp variable
TTL mode output: 5 Vpp
5. 16 BITS DATA SWITCHES:
16 pcs of toggle switches and corresponding output point. When switch is set at "down" position, the output
is LO level; contrarily, it is to be HI level while setting at "up" position.
6. SPEAKER: 2-112 inch diameter, 8 Ohm/0.25W to be used for load.
7. FOUR CHANNEL ADAPTER:
Both of the two banana sockets' and two BNC jacks' point tips are changeable. It is suitable for the station to
be connected with peripherals.
8. TWO DIGITS OF SEGMENT LED DISPLAY:
9. TWO PULSE SWITCH (WITH 2 SETS OF OUTPUT):
2 pcs of pushbutton contain switches debouncer for eliminating the bounce caused by switch from "open" to
"close" or from close" to "open" position.
10. 16 BITS LED DISPLAY:
16 red LED's separate input terminals. The LED will be lighted up when input is at "Hi level", and it will be
turned off when it is at no input or at "LO level".
11. UNIVERSAL CONNECTOR FIXED HOLDER:
It reserves universal connector fixed holder on the panel in order to be connected with various universal
connectors, which are available as below:
Optional Accessories
.(1) UC-01 :Card edge connector 2.54mm 62pin
.(2) UC-02: RS-232 connector 25 pin D sub connector, male & female
.(3) UC-03: Straight header 60 pin.
.(4) UC-04: Card edge connector 3,96mm 28 pin
12. STANDARD ACCESSORIES:
(1) Power cord
(2) Pin: 6pcs
(3) Breadboard, 2820 tie points
(3) User manual
13. DIMENSIONS: 250 x 95 x 325 mm (W x H x D)
14. WEIGHT. (4.3kg)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement