Automotive Data Solutions ADS-AL(DL)-HA2 Honda Civic 2006 Installation Guide

Automotive Data Solutions ADS-AL(DL)-HA2 is an all-in-one device designed for Honda and Acura vehicles. It integrates key features for remote start, alarm control, and vehicle access, providing a comprehensive solution for enhancing security and convenience. This device is intended for installation by certified technicians and is compatible with a range of Honda and Acura models.

PDF Download
Document
Automotive Data Solutions ADS-AL(DL)-HA2 Installation Guide Honda/Acura | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Remote Start
  • Alarm Control
  • Data Immobilizer Bypass
  • Power Liftgate Control
  • Door Status Output
  • Trunk Status Output
  • Hood Status Output
  • Integration with OEM Remote Controls
  • Automatic Relock After Start
  • Data Mode and Hardwire Mode

Frequently asked questions

The manual lists compatibility with specific years and models, including Fit, Insight, MDX, CSX, Civic, Civic Hybrid, CR-V, and CR-Z. Refer to the 'Install Type Selection' table for the most updated information. This solution does NOT cover hybrid vehicles with a manual transmission. Do not, under any circumstances, attempt to install.

You can press and release the programming button to select between Data Mode or Standard Hardwire Mode. The LED will flash once for Data Mode and twice for Hardwire Mode. You can then press and hold the button until the LED turns solid green to register your selection. You can also adjust your selection later with the Factory Reset Procedure.

The 'Ground When Running' feature is essential for the immobilizer bypass during remote start. It must be provided BEFORE ignition. Failure to comply may result in immobilizer bypass malfunction during remote start.

The Factory Reset Procedure allows you to reset the module to its default settings. You can use this procedure to change the installation mode and restart the programming process. Disconnect all connectors except the black 4-PIN standard or optional data connector, then press and hold the programming button while connecting either connector.

During programming, the LED can indicate different statuses. Flashing red indicates missing/wrong information, while solid red means the module is waiting for more information. Flashing green indicates additional steps are required, and solid green signifies successful programming. Refer to the 'Module Diagnostics' section for more details.
Preparing document for printing…
0%