Advertisement
Advertisement
HF-008 Quick Guide The antenna comes with: ① Black part (with 9 holes for plugging in the jumper cable) with silver colored body (total mechanical length 67 cm / 26.4 in) ② Long (L) top radial with a variable active length between 46.5 cm / 18.3 in and 77.5 cm / 30.5 in ③ Short (S) top radial with a variable active length between 25.5 cm / 10 in and 56 cm / 22 in ④ Silver extension radial (fixed length of 31.7 cm / 12.5 in) ⑤ Jumper cable for use with black part ⑥ 2mm Allen-key (required to move the fixing part of the S and L top radial) ① ② ③ ④ 1 ⑤ ⑥ Visible length of top Total silver radial (without the radial length Which top f [MHz] l [m] Band Jumper radial to use extension and without (extension plus the black part) top radial) 3.56 84.21 80 no S 42cm / 1.4ft 73.7cm / 2.4ft 7.05 42.52 40 2 S 31cm / 1.0ft 62.7cm / 2.1ft 10.10 29.68 30 3 S 31cm / 1.0ft 62.7cm / 2.1ft 14.00 21.41 20 4 S 44cm / 1.4ft 75.7cm / 2.5ft Length The following table shows how to set the length of the short (S) / long (L) radial: 9 8 7 6 5 4 18.00 16.66 17 5 L 54cm / 1.8ft 85.7cm / 2.8ft 3 21.10 14.21 15 6 S/L 46.5cm / 1.5ft 78.2cm / 2.6ft 2 24.90 12.04 12 7 S 41.5cm / 1.4ft 73.2cm / 2.4ft 27.00 11.10 11 8 S 41cm / 1.3ft 72.7cm / 2.4ft 29.00 10.34 10 8 S 26.5cm / 0.9ft 58.2cm / 1.9ft 50.00 6.00 6 9 S 25.5cm / 0.8ft 57.2cm / 1.9ft 1 How to setup the antenna for use of a specific band: 1. Select the listed top radial according to the frequency you plan to use. 2. Mount the top radial into the extension radial. 3. Mount the extension radial onto the black part. 4. Release the grub-screw of the fixing part (just a little turn counterclockwise) to align the length of the top radial. 5. Tighten the grub screw of the fixing part (by turning the grub screw clockwise). 6. If required, plug in the patch cable accordingly. One side of the patch cable is always (except for 80m band) plugged into hole 1. 2 ">

Public link updated
The public link to your chat has been updated.
Advertisement