Razor | RipRider 360 | RIPRIDER™360° SERVICE BULLETIN INSERTING THE CASTERS

RIPRIDER™360° SERVICE BULLETIN
INSERTING THE CASTERS
Tools Required: (Not included)
A. 5mm Allen wrench
Step 1
Step 2
Insert the caster bolt into the frame. If aligned
correctly, the caster thread should go half way into
the frame with no resistance (A).
Using a 5mm Allen wrench, tighten the hex bolt
located on the underside of the wheel cover until
the caster bolt is all the way inside the frame.
Note: Make sure the spring washer is on the
caster bolt before installing the caster.
Note: There should be no visible threading between the frame and the wheel cover (See Insert)
Spring
Washer
A
Figure 1
Figure 2
Helpful Tip
If you’re having trouble threading the caster into
frame, use a rag or small brush with a little
WD-40® to remove any excess particules that
may be caught in or around the threading inside
the frame.
Figure 3
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
Download PDF

advertising