Dynacord CXM15 Broschyr
preliminary
CXM 15
Coaxial Monitor speaker cabinet
Mobile Audio | Concert Sound | Fixed Installation | Pro Entertainment
English
CXM 15
CXM 15
Coaxial monitor speaker cabinet
• Coaxial Monitor 15“/1.4“ 2-Way
• 102dB SPL/1W/1m
• Max. 135dB SPL/1m (calculated with peak power)
• Light Weight 19kg
• Switchable to Biamp Mode
• FIR and IIR Presets available
The DYNACORD CXM15 is a
light-weight wedge for professional monitoring applications.
The DYNACORD DCX15450
2-Way 15”/1.4” transducer uses a coaxially mounted HF unit and
can be used in passive or biamped
operating mode.
The acoustic crossover frequency
from the 15” low-frequency transducer to the 1.4” mid-high compression driver is around 1.2kHz.
The slope of the built-in passive
crossover network is 12dB/Octave.
An extremely precise definition of
the vocals is guaranteed due to the
2
comparably low crossover frequency
and the coaxial transducer design.
Power amplifiers are connected to
the CXM15 via Speakon connectors NL4MPR.
The pin assignment in passive mode
is 1+, 1-.Switching from passive
mode to biamped mode is performed
by operation of a slider switch. In
biamped mode pins 1+, 1- are connected to the 15” low frequency
section of the CXM15, pins 2+,
2- are then connected to the 1.4”
mid-high-frequency section of the
CXM15. The CXM15 is equipped
with 3 Speakon connectors wired
in parallel. This simplifies the
daisy-chaining of multiple wedges
and polemounted CXM15 cabinets.
The 1.4” mid-high frequency
compression driver is protected
against thermal overload with an
electronic circuit called VOICE
COIL TRACKING PROTECTION. The
protection circuitry exhibits “soft”
switching characteristics, so no
annoying clicks or pops are audible
in case of a thermal overload situation.
FIR and IIR presets are available
for all operating modes.
The CXM15 is manufactured from
birch plywood and therefore extremely
resistant against abuse on the
road. All cabinet connections are
slotted and glued. The surface is
painted with a 2-component paint
that can easily be renovated if
sometimes necessary. A powdercoated steel grille equipped with
acoustic foam on the inside protects
the transducers against accidental
damage. A recessed flange allows
easy pole-mount operation and
can be exchanged with a M20 inside
thread plate for flying applications.
Handles have been integrated into
both sides of the CXM15.
CXM 15
Frequecy response
General
Color
Order No.
Cabinet
Configuration
Impedance
CXM 15
CXM 15W
Black
White
F.01U.123.934
F.01U.123.935
Fullrange
Fullrange
Passive 2-Way
Passive 2-Way
Switchable to biamped mode
Switchable to biamped mode
Nominal impedance
8 Ohms
8 Ohms
Power Handling
Fullrange
Fullrange
450 W
450 W
Rated Power RMS
Program Power
900 W
900 W
Peak Power
1800 W
1800 W
Power Handling
Biamped
Biamped
LF Transducer
400 W
400 W
HF Transducer
50 W
50 W
102 dB SPL
102 dB SPL
135 dB
135 dB
Frequency range (-10dB)
100 Hz - 18 kHz
100 Hz - 18 kHz
Nominal Coverage Angle
60˚ Conical
60˚ Conical
LF Transducer
DCX 15450 - F01U126730
DCX 15450 - F01U126730
HF Transducer
DCX 15450 - F01U126730
DCX 15450 - F01U126730
Yes
Yes
Sound pressure level
SPL 2.83 V / 1 m 1 W / 8 Ohm
Max. SPL 1m
(calculated with peak power)
Speaker components
Voice Coil tracking protection
Connectors Full-Range
1+, 1-
1+, 1-
Wired through
2+, 2-
2+, 2-
Lo 1+, 1-, Hi 2+, 2-
Lo 1+, 1-, Hi 2+, 2-
Connectors Biamped
1+, 1-, 2+, 2-
1+, 1-, 2+, 2-
Speakon 3x NL4 MPR
Speakon 3x NL4 MPR
Net weight
19 kg ( 41,88 lbs)
19 kg ( 41,88 lbs)
Shipping weight
21 kg ( 46,29 lbs)
21 kg ( 46,29 lbs)
Bitch plywood
Bitch plywood
Powder coated steel, acoustic
foam
Powder coated steel, acoustic
foam
Handles
integrated handles
integrated handles
Warranty
36 Months
36 Months
Wired through
Connector model
Enclosure material
Grille
3
Americas
EMEA
Asia & Pacific
Headquarters Americas
Bosch Security Systems, Inc.
12000 Portland Ave South,
Burnsville, MN 55337, USA
USA–Ph: 1 800 392 3497
Fax: 1 800 955 6831
Canada–Ph: 1 866 505 5551
Fax: 1 866 336 8467
Latin America–Ph: 1 952 887 5532
Fax: 1 952 736 4212
Headquarters Europe,
Middle -East & africa
Bosch Sicherheitssysteme GmbH
Robert-Koch-Strasse 100
85521 Ottobrunn, Germany
Headquarters APR
Robert Bosch (SEA) Pte Ltd
38 C Jalan Pemimpin
Singapore 577180
Phone: +65 6319 0616
Fax: +65 6319 0620
Contact & Visitor Address
EVI Audio GmbH
Hirschberger Ring 45
94315 Straubing, Germany
Phone: +49 9421 706 0
Fax: +49 9421 706 265
Australia
Bosch Security Systems Pty Ltd
Phone: +61 2 9683 4752
Fax: +61 2 9890 5928
France
EVI Audio France S.A.S
Phone: +33 1 6480 0090
Fax: +33 1 6006 5103
China
Telex EVI Audio
(Shanghai) Co., Ltd.
Phone: +86 21 6317 2155
Fax: +86 21 6317 3025
middle east
Robert Bosch Middle East FZE
Phone: +97 14 212 3300
Fax: +97 14 212 3388
India
Bosch Limited
Phone: +91 80 4176 8378
Fax: +91 80 4176 8263
Japan
EVI Audio Japan
Phone: +81 3 5316 5020
Fax: +81 3 5316 5030
Thailand
Robert Bosch Limited
Phone: +662 639 3111
Fax: +662 631 2030
© Bosch Security Systems, Inc. · Art.Nr. D164711 · Printed in Germany (BECK/DR) · 2000/03/09 · Subject to change without prior notice!
www.dynacord.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement