ICO A3200 Standard Control Instructions

Tuzio Towel Warmer Controller
Programming & Troubleshooting
1 Power On
1 Pry the switch door open from the
bottom using a small screwdriver.
2 Ensure the ON/OFF selector is set
to ON.
Reset the switch using a
3
paperclip. 0:00 and MO will flash.
2 Setting the Clock
Set the time using the HOUR and MIN buttons.
2 Set the day by using the DAY button.
3 Press one of the control buttons or close the switch door
to return to normal operation.
4 Programming
You can set up to 7 programs. To set a program, you need to
enter its start time (ON) and its end time (OFF).
1
2
3
1
4
5
3 Selecting the Operating Mode
The programmable switch has 2 operating modes: manual
(MAN) and automatic (AUTO). To switch mode, press the timer
door for 3 seconds.
Manual Mode
The programmable timer operates as a regular
switch. Briefly press the switch door to turn the
towel warmer On or Off. The mode (MAN) and
state (ON or OFF) are displayed.
Automatic Mode
The programmable timer follows the
programmed schedule. The mode (AUTO),
state (ON or OFF) and current program
number are displayed. To temporarily override
the programmed schedule, briefly press the
switch door. The new state (ON or OFF) will flash to show that
this state is temporary. The override remains in effect until you
press the timer door again or until the beginning of the next
program.
6
7
8
Pry the timer door open using a small screwdriver.
Press the PGM button to display a
program and its On or Off time. For
example, when you first press PGM,
program number 1 (P1) and its On time
(ON) will appear. -:-- will appear
instead of the time if the program is not set (inactive).
Press the DAY button to select the day
to which you want to apply the program.
NOTE: If you want to apply the program
to every day of the week, press DAY
until all the days are displayed. (This
still counts as 1 program, not 7)
Press the HOUR and MIN buttons to set the ON time
(time when you want the towel warmer to turn on)
After you have programmed the ON time, press the PGM
button to display the OFF time (time when you want the
towel warmer to turn off).
Repeat steps 3 through 5 to program the OFF time. If the
program ON time is set for every day of
the week, the program OFF time will
automatically be set for every day.
To set another program, repeat steps 2
through 6. Programs that are not set will
remain inactive.
Press one of the control buttons or close the timer door
to return to normal operation.
Clearing a Program
Press the PGM button until the desired program is selected.
Hold the PGM button for 3 seconds. -:-- appears when the
program is erased.
5 Troubleshooting
Blank display
 Verify circuit breaker at main
panel.
 Ensure the ON/OFF selector is at
ON.
 Reset the switch using a paper
clip.
Programs do not run
as expected
 Make sure the switch is properly
programmed.
 Note that -:-- indicates an inactive
program, 00:00 indicates
midnight.
">