Insight Sill Mini (SIS) Installation Instructions

SILL MINI
VISOR INSTALLATION
Black Linear
!
WARNING:
Install product in accordance
with local/NEC codes.
Disconnect power during
installation and servicing.
!
Failure to comply
with the installation
instructions may
result in death or
serious injury.
Read all safety
instructions included
with product before
installing.
CAUTION:
+
Insight Lighting is not responsible
for the structural integrity of the
building to the luminaire. Additional
backing may be required.
WIRING
DIAGRAM
SPECIFICATION
SHEET
FIXTURE + VISOR PROFILE
INSTALLATION STEPS
1
PRODUCT INFORMATION:
Care must be taken during storage and handling.
Store in a clean, cool and dry location.
Electrostatic discharge can harm this product.
Avoid static discharge while handling this product.
Remove from luminaire (A) 8-32 socket
head screws (C) and gasket washers (D).
2
Align visor (B) on top of luminaire (A).
3
Secure visor to luminaire with 8-32 socket
head screws and gasket washers from step 1.
3
C
1
5/64” 6LB. TORQUE HEX
DRIVER NEEDED FOR SCREWS
(BY OTHERS)
COMPONENTS
A
B
C
x4
D
x4
0.375”
B
2
LUMINAIRE
VISOR
832 SOCKET
HEAD SCREW
GASKET
WASHER
INSTALLATION TYPE
A
Revised: August 21, 2023
Specifications subject to change without notice
Black Linear
4341 Fulcrum Way NE, Rio Rancho,
New Mexico 87144
P: 505.345.0888 | insightlighting.com
">