BMR Suspension UCA631 Upper control arms Installation Instructions

Upper Control Arm Installation Instructions
Tools Required:
•
•
•
Hydraulic jack and jack stands
Metric socket and wrench set
Allen bits
Installation:
1. Lift the rear of the vehicle and safely support
on jack stands. Remove both rear wheels.
2. Using an 18mm wrench, socket, and ratchet
remove the outer nut and bolt as shown in
IMAGE 1
3. Using the same tools, repeat the process for
the inner nut and bolt
4. Once removed, ensure the length of this
adjustable upper control arm matches the stock length hole-to-hole. Tighten jam nut to
45 ft-lbs. IMAGE 2
5. Install the BMR upper control arm, bearing end
first. Re-install inner nut and bolt, leave finger
tight.
6. Install outer bolt and nut.
7. Use the torque specs above if you have replaced
your hardware, if not torque the outer and inner
bolts to 70 ft-lbs as in IMAGE 3
8. Re-install the wheels/tires and lower the vehicle.
It is recommended to have the vehicle
profefssionally aligned after installation
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such,
Buyer assumes all risk of any damage caused to the vehicle or person during installation or use of this product.
1
">