Slip-On (2010
Installation Instructions
1.
Make sure the bike is completely cool before starting
the installation. Make sure the bike is secure on a
stand or ideally a service lift.
2.
Remove OEM muffler assembly.
3.
Attach TBR muffler to supplied slip-on tube using the 4
socket head cap screws and thread-lock provided.
5.
Check alignment and then tighten muffler mount
bolt and finally barrel clamp.
6.
Before you run the bike, clean off all fingerprints
and dirt, as any oily residue will etch the metal and
become somewhat permanent when the system
gets hot. Also, remove any protective plastic from
the name badges on the muffler canister(s) or the
muffler clamp(s). Run the bike and enjoy. It is normal
for some white smoke to appear the first time you
start the bike. This is packing/manufacturing oil from
inside the pipe burning off. After 50 to 100 miles,
recheck all fasteners for tightness.
V.A.L.E.
TM
2010 BMW
V a r i a b l e
A x i s
L o c k i n g
E x h a u s t
S1000RR
Slip-on Exhaust System
Part# 005-2810406V-B / 005-2810407V-B / 005-2810408V-B
Parts List
Qty.
1
1
1
4
1
1
1
1
Description
Muffler Canister
Slip Tube
HARDWARE KIT
6x20mm Socket Head Cap Screws
8mm Flange Nut
5mm Long Handle Ball End Hex Key T20 Torx Hex Key
TBR Sticker Kit
Part Number
Varies
005-28104S
005-281-3
005-SH620
005-FN8
005-9-18610
005-9-15820
015-10212
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance
part, please consult with your local motorcycle dealer. Read all instructions first
before starting installation. Make sure the motorcycle and exhaust system are
completely cool before starting the installation. Also, make sure the bike is secure
on a centerstand or ideally a service lift during installation. Be sure to save all stock
components for possible use later.
**This product has not been tested with all available accessories and some
items may cause excessive heat. Excessive heat may cause damage to your
vehicle. Two Brothers Racing will not be responsible for damaged parts.
Warranty
Two Brothers Racing products are intended for closed course competition purposes only, and therefore are sold “as
is” without warranty. Two Brothers Racing specifically disclaims any warranties of merchantability or fitness for a
particular purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising
from the use of these products or parts.
4.
Install TBR muffler assembly to bike, use supplied nut with OEM bolt on muffler bracket mount.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement