OWNER’S MANUAL FOR THE E3X4TBT TRAILER
CONGRATULATIONS!
You are now the proud owner of a BARRETO trailer. The following pages have important safety
information as well as a detailed view of your trailer, along with corresponding part numbers. If
you have any questions or need any replacement parts in the future, please contact us at your
convenience. Our toll-free phone number, fax and email are listed below and parts may be
ordered through any of these methods.
THANK YOU for your patronage and confidence in BARRETO equipment.
Barreto Manufacturing, Inc.
Innovative Equipment Engineered to Last
66498 Hwy 203, La Grande, OR 97850
(800) 525-7348 (541) 963-7348
FAX (541) 963-6755
E-Mail: [email protected]
Web Site: http://www.barretomfg.com
The Barreto Tilt Bed Trailer, Model Number E3X4TBT, is designed specifically and solely for
transporting Barreto tillers. It has a special bracket for locking the tiller in place while in transit.
There are no provisions for any other type of tie-down apparatus, which makes it ill-suited and
unsafe for hauling anything except Barreto specifically designed equipment.
Using the Barreto Model E3X4TBT trailer for any purpose other than transporting Barreto tillers
could pose a safety hazard and would null and void any manufacturer’s warranty and/or liability.
Barreto Manufacturing, Inc. accepts no liability for damage to the trailer or transported goods
other than Barreto specifically designed equipment. Barreto Manufacturing, Inc. also accepts no
liability for injury or damage of any kind related to unauthorized use of the Barreto Tilt Bed
Trailer.
Be sure to read and observe the safety instructions for proper use of the Barreto Tilt Bed Trailer.
If there are any questions regarding proper use, please contact Barreto Manufacturing, Inc. or an
authorized Barreto Dealer.
E3X4TBT OWNER’S MANUAL
9/5/18
Page 1 of 9
SAFETY INSTRUCTIONS/CHECKLIST
Be sure to obey all traffic laws and rules of the road while towing the Barreto Tilt Bed Trailer.
Never exceed 45 miles per hour while towing the trailer. The towing vehicle should be in legal
operating condition. If local law requires trailer lights, be sure they are in good repair and are in
proper working condition.
Refer to the following checklist before towing:
•
Towing vehicle should have a 2" ball. Be sure it is in good repair and securely fastened to
the vehicle.
• Securely fasten the hitch to the ball by tightening the hitch nut.
• Cross the chains under the trailer tongue to prevent the tongue dropping to the ground if the
trailer comes loose.
• Attach the safety chain to the towing vehicle in such a way that it cannot come off
accidentally.
• Check the hitch-to-ball connection after driving a few blocks and re-tighten if necessary.
• Allow only enough slack in the chains to permit proper turning of the vehicles. Do not let
chains drag on the ground or be drawn up too tight. Slack strength should hold the tongue
and coupler off the ground with the trailer loose.
• The bolts that hold the lock-on chain to the trailer should be in good repair. These bolts
prevent the tiller from shifting from side to side.
• The clevis pins should be placed behind the tiller bumper with clips in place to prevent
bouncing out.
• Do not use the Barreto Tilt Bed Trailer for any purpose other than transporting a Barreto
Tiller!
Always exercise extreme caution and allow extra clearance while towing a trailer.
DRIVE SAFELY!
E3X4TBT OWNER’S MANUAL
9/5/18
Page 2 of 9
BARRETO MANUFACTURING, INC. EQUIPMENT WARRANTY
Barreto Manufacturing, Inc. warrants all BARRETO equipment to be free of defects in material
and workmanship for a period of one (1) year, dating from the delivery to the original user.
This warranty is in lieu of all other warranties, whether written or implied, and is limited to:
1. Replacement of parts returned to the dealer and/or factory and determined defective
upon inspection. (Replacement for parts to dealers shall be at dealer cost plus
shipping charges.)
2. Time for pick-up and/or delivery, transportation of service calls by dealers is
excluded. Manufacturer reserves the right to determine reasonable time
required for repair.
Warranty does not apply to damage caused by abuse or neglect. Time and materials required
for normal maintenance and service are also excluded from warranty coverage.
Engines, engine accessories, batteries and tires are warranted by the original manufacturers
and are not covered by the Barreto Equipment Warranty. Wear parts such as tiller tines,
sprockets, bearings, trencher chain parts including teeth, stump grinder cutting teeth & holders,
etc. are also excluded unless it can be determined that a defect has contributed to premature wear.
SPECIFICATIONS
DIMENSIONS
U.S.
Metric
Empty Weight
260 lbs.
117.93 kg
Gross Weight
900 lbs.
408.23 kg
Length
7’5”
2.26 m
Width
4’3/4”
1.24 m
Bed Size
3’ x 4’
.91 x 1.22 m
E3X4TBT OWNER’S MANUAL
9/5/18
Page 3 of 9
">