SAMARAN LED
CEILING FAN LIGHT KIT
INSTALLATION INSTRUCTION
Model: 3-9-116
READ AND SAVE THESE INSTRUCTIONS
WARNING! RISK OF ELECTRIC SHOCK
All electrical connections must be in accordance with local codes, ordinances, or national codes. If
you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified
electrician.
Before starting installation, disconnect the power by turning off the circuit breaker or removing the
fuse at fuse block. Turning power off using fan switch (speed control on/off) is not sufficient to
prevent electrical shock.
NOTE: The important safeguards and instructions appearing in this manual are not meant to cover
all possible conditions and situations that may occur. It must be understood that common sense,
caution and care are factors which cannot be built into any product. These factors must be supplied
by the person (s) caring for and operating the unit.
1. While holding the LED light kit under the
fan motor assembly, make the 2-pin wire
connections: (Fig. 1)
-White to white
-Black to black
2. Position the notches in the the light kit so
they line up with the tabs on the mounting
plate. Secure it to the fan by turning the
light kit clockwise until snug.
3. Restore power and your light kit is ready
for operation.
Mounting plate
Connection plugs
Light kit
Fig. 1
">
