Allen-Bradley PowerFlex 527 Removable Terminal Blocks Kit Installation Instructions

Installation Instructions
5012622500
2015 T 03
*
5
7
PowerFlex 527 Removable Terminal Blocks Kit
Catalog Number: 25C-RCTB
1
L1
2
L2
L3
I
DC+ DC–
0V
0V
O
25C-RCTB
3
Separate the Control Module and Power Module
Press and hold to unlatch the top cover and slide out
Note: Top cover cannot be removed
Press and hold the sides to
unlatch the power module
cover and lift out
Publication 520-IN015A-EN-P - March 2015
Grip the top cover and sides of the
control module firmly and pull out
Wait three minutes after shutdown
for capacitors to discharge to safe
voltage levels.
PowerFlex 527 Removable Terminal Blocks Kit
4
Remove the Control Module Terminal Blocks
IMPORTANT
5
Install the Control Module Terminal Blocks
It is recommended to remove the control wires before
removing the control terminal blocks.
Grip the flat surface of the terminal block
firmly and pull out
Note: Remove the big terminal block first,
followed by the small terminal block
Align the terminal blocks and push in
Note: Install the small terminal block first,
followed by the big terminal block
Press and hold the triangle to unlatch the
front cover and slide out
Install the front cover after replacing the
terminal blocks
U.S. Allen-Bradley Drives Technical Support - Tel: (1) 262.512.8176, Fax: (1) 262.512.2222, E-mail: [email protected]
Online: http:// www.ab.com/support/abdrives
Rockwell Automation maintains current product environmental information on its website at
http://www.rockwellautomation.com/rockwellautomation/about-us/sustainability-ethics/product-environmental-compliance.page
Allen-Bradley, Rockwell Software, Rockwell Automation, PowerFlex, and TechConnect are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Publication 520-IN015A-EN-P - March 2015
Copyright © 2015 Rockwell Automation, Inc. All rights reserved.
">