Installation Instructions
PowerFlex® 755 Transition Section and Splicing Kit
ATTENTION: Only qualified personnel familiar with adjustable frequency AC drives and
associated machinery should plan or implement the installation, start-up, and
subsequent maintenance of the system. Failure to comply may result in personal injury
and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, verify that the voltage on the bus
capacitors has discharged completely before servicing. After removing power to the
drive, wait 5 minutes for the bus capacitors to discharge. Measure the DC bus voltage at
the DC+ and DC- TESTPOINT sockets on the front of the power module. The voltage
must be zero.
ATTENTION: HOT surfaces can cause severe burns. After disconnecting power allow
time for cooling.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts and
assemblies. Static control precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD control procedures are
not followed. If you are not familiar with static control procedures, reference Guarding
Against Electrostatic Damage, publication 8000-4.5.2 or any other applicable ESD
protection handbook.
ATTENTION: Hazard of permanent eye damage exists when using optical transmission
equipment. This product emits intense light and invisible radiation. Do not look into
module ports or fiber optic cable connectors.
Finding Specific Information
Installation information for this part can be found in the PowerFlex 755
Transition Section and Splicing Kit for Floor Mount Drives and CENTERLINE
2100 Motor Control Centers, publication 750-IN027 available online at:
www.rockwellautomation.com/literature
Rockwell Automation Support
Before you contact Rockwell Automation for technical assistance, we suggest you
please review the troubleshooting information contained in the supporting
product publications first (e.g. Hardware Service Manual, Installation
Instructions, Programming Manual, etc.).
If the difficulty persists, call your local distributor or contact Rockwell
Automation in one of the following ways:
Phone
United States/Canada
1.262.512.8176 (7 AM - 6 PM CST)
1.440.646.5800 (24 hour paid support available through the
TechConnect Support Program)
Outside United
States/Canada
You can access the phone number for your country via the
Internet:
Go to http://www.ab.com
Click on Support
(http://support.rockwellautomation.com/)
Under Contact Customer Support, click on Phone Support
Internet
Go to http://www.ab.com/support/abdrives/
E-mail
[email protected]
Be prepared to furnish the following information when you contact support:
• Product Catalog Number
• Product Serial Number
• Firmware Revision Level
*PN-154896*
PN-154896
Publication 750-IN028A-EN-P - May 2012
Copyright © 2012 Rockwell Automation, Inc. All rights reserved. Printed in the U.S.A.
">
