Installation Instructions
PowerFlex® 750-Series Spare Parts
ATTENTION: Only qualified personnel familiar with adjustable frequency
AC drives and associated machinery should plan or implement the
installation, start-up, and subsequent maintenance of the system. Failure
to comply may result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, verify that the voltage on
the bus capacitors has discharged completely before servicing. After
removing power to the drive, wait 5 minutes for the bus capacitors to
discharge. Measure the DC bus voltage at the DC+ and DC- TESTPOINT
sockets on the front of the power module. The voltage must be zero.
ATTENTION: HOT surfaces can cause severe burns. After disconnecting
power allow time for cooling.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive
parts and assemblies. Static control precautions are required when
installing, testing, servicing or repairing this assembly. Component
damage may result if ESD control procedures are not followed. If you are
not familiar with static control procedures, reference Guarding Against
Electrostatic Damage, publication 8000-4.5.2 or any other applicable ESD
protection handbook.
ATTENTION: Hazard of permanent eye damage exists when using optical
transmission equipment. This product emits intense light and invisible
radiation. Do not look into module ports or fiber optic cable connectors.
Finding Specific
Information
Installation information for this part can be found in the PowerFlex 750-Series
Hardware Service Manual, publication 750-TG001 available online at:
www.rockwellautomation.com/literature
Rockwell Automation
Support
Before you contact Rockwell Automation for technical assistance, we suggest you
please review the troubleshooting information contained in the supporting
product publications first (e.g. Hardware Service Manual, Installation
Instructions, Programming Manual, etc.).
If the difficulty persists, call your local distributor or contact Rockwell
Automation in one of the following ways:
Phone
United
States/Canada
1.262.512.8176 (7 AM - 6 PM CST)
1.440.646.5800 (24 hour paid support available through
the TechConnect Support Program)
Outside United
States/Canada
You can access the phone number for your country via
the Internet:
Go to http://www.ab.com
Click on Support
(http://support.rockwellautomation.com/)
Under Contact Customer Support, click on Phone
Support
Internet
Go to http://www.ab.com/support/abdrives/
E-mail
[email protected]
Be prepared to furnish the following information when you contact support:
• Product Catalog Number
• Product Serial Number
• Firmware Revision Level
*PN-51197*
PN-51197
Publication 750-IN013A-EN-P - April 2010
Copyright © 2010 Rockwell Automation, Inc. All rights reserved. Printed in the U.S.A.
">
