ubuy MD-091P Multi Function Emergency Radio User Manual

Note: Please turn on the power switch(on the back side) to
"ON" before using each function.
When the radio is on, press “WX AL” button to switch to
weather alert mode. Once receives bad weather information, "ALERT " will f lash on the screen and the
device will alarm.
Press button “WX AL” or “BAND” to exit weather alert
mode.
RADIO OPERATION
Solar Panel
LCD
Display
Speaker
Flashlight Button
Power on Indicator
Signal Indicator
Charging Indicator
Flashlight
Antenna
The charging indicator light will light red when the
handle is being turned.
Flashlight button
Rotate the rocker clockwise or counterclockwise,
and keep it at a constant speed of 130 rpm for 1
minute, which can be used for far beam or dipped
beam for 10 minutes or radio work for 5-6 minutes.
C SOLAR POWER
SOS ALARM
Alert
Tuning
VOL +/-
Power ON/OFF
Band Selector
Turn on the radio by pressing the power button, press
it again to turn it off.
Press the left or right buttons to navigate between
radio stations. Adjust the volume by pressing the
volume buttons.
The green LED will light up when the radio has found a
stable reception/channel.Ex tend the antenna and
adjust the direction to get better signal.
The blue LED will light up when the batteries are being
used
The waterproof cover on the side of this product has 2
Long press the SOS button for 3s to activate the loud
Power switch
The first press on the flashlight button, the far beam
READING LAMP
Open the solar panel, the reading lamp lights up, and
close the solar panel it will light off.
Insert the 3.5mm Earphone jack to listen to the radio
over-disacharged and damaged.
to enjoy your leisure time.
device is used as a power bank (discharge), the power
indicator lights will diminish.
This feature is suggested to use in emergency, do not
use it as a normal power bank.
If you press the SOS button at this time, you will hear
Earphone jack
Please have the radio charged at least once every
Frequency range
FM 87~108MHz
AM 520~1710KHz
WB/ALERT:
WARRANTY
The device has a full 12-month warranty against manufacturing defects from the date of purchase.
Radio x 1
User Manual x 1
175x80x98mm
USB-C Cable x 1
Gift box x 1
Weight
570g
For the first use or when the unit idles over 60 days,
Power consumption
7w
please hand crank for 1 minutes to activate the internal
Working voltage
2.4~4.2V
Power source
10000mAh / 3.7V
The device shall not be exposed to dripping or
Power input
USB-C 5V 2A
Waterproof level
IPX3
Please do not over discharge the unit, so as not to
LED flashlight
200LM(Max)
reduce the internal battery life, or even damage the
Power of flashlight
2W
battery.
Power of reading lamp
1.2W
User manual
Multi-function Emergency Radio
With LCD Screen
Avoid flashlight light directly into the eyes, or it will hurt
the eyes.
-7-
-8-
-9-
damage when there is an overload or a short circuit in
-6-
-5-
Dimensions
battery.
power supply will be cut off to protect the battery from
this unit.
PACKING LIST
CARE AND MAINTENANCE
This emergency radio is designed with a feature of
shutdown in low voltage. To protect the chip, the
B HAND CRANK POWER
1: 162.400 MHz 2: 162.425 MHz
3: 162.450 MHz 4: 162.475 MHz
5: 162.500 MHz 6: 162.525 MHz
7: 162.550 MHz
radio function when you turn off the SOS function.
prolong the battery life.
BATTERY PROTECTION
three months.
-4-
the SOS alarm in the earphone. It will return to the
placed on the device.
Input port
light up.
beam lights up.
SPECIFICATION
splashing,and objects filled with liquids should no tbe
Output ports
It is mostly used for maintaining the battery, to
at the back of the device.
lower than 2.7V and protects the battery from being
The charging effect depends on the intensity of the
sunlight. Stronger sunlight give better effect.
The second press on the flashlight button, the dipped
-3-
The charging indicator will turn red when charging.
on the unit's right side to charge the built-in lithium
battery. Meanwhile, the red charging indicator light will
The third press with both far and dipped beam light up.
efficiently as possible.
Connect the supplied USB-C cable to the USB Input port
The radio can also be charged by turning the handle
EARPHONE JACK
unit via USB cable to power the USB device. When the
USB output ports , a USB input port and a earphone jack.
lights up.
The forth press with both light off.
It will cut of the power source when the voltage is
Connect the USB device to the USB output port of the
Hand crank handle
Press the SOS button again to turn it off.
-2-
POWER THE DEVICE
Place the unit in clear sunlight to let it charge as
A USB CHARGING
siren and the flashing far beam
-1-
Made in China
3 POWER METHODS
FLASHLIGHT
SOS Alarm
CONTENTS:
RADIO OPERATION
WEATHER ALERT
SOS ALARM
READING LAMP
FLASHLIGHT
3 POWER METHODS
BATTERY PROTECTION
POWER THE DEVICE
EARHONE JACK
CARE AND MAINTENANCE
SPECIFICATION
WARRANTY
PACKING LIST
WEATHER ALERT
-10-
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
">