Vaisala viewLinc Digi SP Plate manual

Mounting instructions for Digi One SP

Mounting Kit Contents

1 X Mounting plate

2 X Anchors 2 X #8 Screws

1 X Chempad

Chemtronics

C

HE

M

P

A

D

8 X Cable Ties

4 X Dual Lock 1” x 5” strips

1

Remove plate, drill, insert supplied anchors and screws.

Slip metal plate over screws to check for proper alignment.

You may wish to mark the holes then attach the logger and Digi unit to the plate before installing on wall.

Large

Digi

A

B

Small

Digi

Note: Use holes A and C for large Digi unit, and holes B and C for small Digi unit

C

Front

Note: Screws sit out from the wall to allow metal plate to slip on

(A little more than plate thickness)

Wall

IMPORTANT! To ensure proper adhesion wipe all surfaces, to which

Dual Lock will be attached, with the enclosed Chempad.

When installing using 3M Dual Lock:

First wipe surface, on which the plate will be installed, with Chempad and wait until dry. Apply all 4 strips of Dual Lock to rear side of plate (as per drawing below).

At this point you may wish to attach the logger and Digi unit to the plate before installing the plate to the surface. Remove backing strip, press plate onto surface and hold for 30 seconds.

l

u al ua D D 3M

Rear View

Dual Lock ck Lo Lo ck ck Lo Lo

A al al Du Du al al Du Du ck ck

3M

3M

Lo Lo al al Du Du

3M Dua

3M

Dua

These tabs are

indented on rear side

B

Surface

Front l

u al ua D D 3M ck ck

Dual Lock ck Lo Lo

Lo Lo al al al al

Du Du

Du Du

C ck ck

3M

3M

Lo Lo al al Du Du

3M Dua

3M

Dua

Digi unit includes

One SP Digi, Serial data cable, Ethernet Cable, power adaptor.

Unit layout

Remove the backing strip from the Dual Lock on the back of the Digi and position it as illustrated below. Note that it does not cover the middle or bottom mounting holes.

Mounting Units on Plate:

2

using Dual Lock. The SP comes with the Dual Lock already applied.

Each logger is supplied with a package including two strips of Dual Lock, a Chempad, and an instruction card. Remember to clean all surfaces with the

Chempad before applying the Dual Lock.

Back of Digi

Dual Lock location

Power cord

Ethernet cable

(route behind probe cable)

CH

LOGGER

Serial data cable

3M Dual Lock

3M Dual Lock ock

3M Dual Lock

L

Back of logger

Dual Lock Positioning

Note: Position probe cable to minimize strain

Cable tie detail

Ethernet Cable

Power Cord

Cable Ties -

One for probe.

Ethernet and power cable share l

u al ua D

3M

3M

3M ck ck Lo Lo

3M Dual Lock ck Lo Lo al al al al

Du Du

Du Du ck ck

3M

3M

Lo Lo al al Du Du

3M

3M

3M

Probe Cable

To tie cable to plate slide cable tie under metal tab and tighten across cable. Note: Probe cable is tied separately