Cellular Shades Installation Instructions

Cellular Shades Installation Instructions
Cellular Shades
Installation Instructions
Mounting Brackets:
Hold shade up to window exactly as you will want it. Make sure it is level (except Angle Tops). For
outside mount, be sure to leave "room for closed shade height" above your window.
Put about a 2" long pencil mark on the wall about 3" in from each end of the shade. For outside or
wall mount, use the top rear edge of the shade for a guide. For inside or ceiling mount, use the top
front edge of the shade for a guide. On shades wider than 42", make a mark for each bracket with
about equal space between the marks.
Put your shade down. Hold a bracket up to each pencil mark as
shown here and mark where the center of the mounting holes are.
Drill holes on these marks. Drill size depends on which type fastener
you choose. Place brackets over holes and drive screws into holes
until they are tight. Do not over tighten. Slots in brackets allow for
some adjustment.
Note: Inside or ceiling mount use center slot and only one
fastener.
Hanging your Shade:
Lock the shade in the fully raised
position (see Operating Your Shade).
Hook the front of the headrail onto Rotate the shade back
the front of the brackets.
to snap in place.
Operating your Shade:
Standard
To lower shade, pull the cord down
and towards the center of the shade
to unlock the cord, then slowly
release the cord until the shade is
how you want it. Move the cord past
the side of the shade and let go to
lock the cord.
Bottom-Up/TopDown
The cord on the right
controls the bottom of the
shade. The cord on the left
controls the top of the
shade. To lower either the
bottom or top of the shade,
pull the right or left cord
To raise the shade, pull the cord down slightly and toward
straight down until the shade is the center of the shade to
how you want it. Move the cord release the cord lock. While
past the side of the shade and let holding the cord towards
go to lock the cord.
the center of the shade, let
the cord run through your
hand until the bottom or
top of the shade is in the
position desired. Pull the
cord to the outside of the
shade and release it to lock
it in place.
To raise either the bottom
or top of the shade simply
pull either the right or left
cord straight down and
release it when the shade is
at the position desired. The
lock will automatically lock
the cord.Hint: Before
raising the entire shade
to the top, raise the top
of the shade all the way
first. Then raise the
bottom of the shade.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising