Kirkland Signature Remote Control 2 Quick Guide

Kirkland Signature Remote Control 2 Quick Guide
TV
Left and right hearing
instrument volume
selected
No streaming device
found
Restaurant
Low battery on left
hearing instrument
TV
Restaurant
Left and right
streaming volume
selected
Low battery on
Remote Control 2
Restaurant
Low battery on right
hearing instrument
TV
Phone program
activated
For more details on the Remote Control 2, refer to
the user guide.
Distributed by:
Costco Wholesale Corporation
P.O. Box 34535
Seattle, WA 98124-1535
USA
1-800-774-2678
www.costco.com
Find out more at Costco.com
400245234-US Rev.A 2013.07
Connected to
streaming device
TV
13V1193b
TV
GETTING STARTED
(Quick Guide)
Remote Control 2
for Model KS562-DRW hearing instruments
B PAIRING YOUR REMOTE CONTROL
A Getting Started
Charging the Battery
Before using your Remote
Control 2, you need to fully
charge the rechargeable
battery. To charge it, plug in
the charging cable as shown
to the right. Then plug the
other end into a power
outlet. During charging, the
bars in the battery meter will
be showing one, two and
three bars continuously.
When fully charged all three
bars will be shown continuously.
NOTE! Check with your hearing healthcare professional
to determine if your instruments have been pre-paired.
Instruments that have been pre-paired do not need to be
paired again.
Turning your Remote Control 2 ON and OFF
To turn your Remote Control 2 ON, slide the switch
on the side of the Remote Control 2 down to the ON
position.
A white ”I” icon will be visible on the base of the switch
and the display will turn on.
To turn your Remote Control OFF, slide the ON/OFF
switch up to the OFF position.
Do not charge the Remote Control 2
while it is on your body.
Make sure the Remote Control 2 is fully charged and is
turned ON.
DISPLAY SCREENS
4.The Remote Control 2 will
search for the hearing instruments.
Basic
1.Open the battery doors on
both hearing instruments
2.Press the pairing button on
the Remote Control 2 to activate
the pairing mode, which will be
active for 20 seconds
3.While in pairing mode, close
the battery doors on both hearing instruments
5.A successful pairing will
be indicated by an audible
melody played in both hearing
instruments, and shown in the
Remote Control 2 display with
active volume bars and program “1”. You are now ready to
use the Remote Control 2!
Searching for both
hearing instruments
Connected to left hearing
instrument and searching
for right hearing instrument
Basic
Basic
Restaurant
Program 1 in left
and right hearing
instrument
Program 2 in left
and right hearing
instrument
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement