Charge Case and Charge Stand 2 User Guide
Charge Case
26W Power Supply
Plug in exteranl mobile devices into USB ports to power them.
Each USB port outputs 6W. The USB ports can charge smart
phones and small tablets.
6W
Charge Case Module
6W
Charge Stand 2
Slide iPad ® into Charge Case. Slide Charge Case top onto iPad.
Ensure a tight fit. Pull from one side of Charge Case top to remove.
Plug Power Supply into wall receptacle. Plug barrel connector into
bottom of Charge Stand. Choose the correct connector if using
outside North America. Place Stand on a flat and solid surface.
Remove iPad from Stand:
1. Pull iPad towards you.
2. Lift iPad from Stand.
OPTIONAL: Remove Module from Charge Case by pushing downward with
finger. Once removed, charge iPad®with Lightning cable (not provided).
NOTE: Charge Case will not charge iPad without Module installed.
Use threaded bosses
to secure Stand 2 to a
Table. Details at
iportproducts.com/support
Secure wire using the
wire channel.
Place Charge Case onto Stand. Magnets will assist with alignment.
Caution: This product contains magnets. Do not place in direct proximity
or
Power Supply:
Input:
AC100-240V~50/60Hz 1.3A
Output: DC 5.2V 5000mA
CAUTION: Only use products as directed.
Unspecified use could result in injury.
Designed and engineered in USA.
Assembled in China.
Warranty & Terms and Conditions at iportproducts.com
with magnetically sensitive objects such as credit cards or exposed hard drives.
Persons with pace makers are not recommended to use this product.
iPort is a trademark of Dana Innovations, registered in the U.S. and
other countries. Copyright 2016, all rights reserved.
iPad is a trademark of Apple Inc., registered in the U.S. and other
countries. “Made for iPad” means that an electronic accessory has
been designed to connect specifically to iPad and has been certified
by the developer to meet Apple performance standards. Apple is
not responsible for the operation of this device or its compliance
with safety and regulatory standards. Please note that the use of
iPort
212 Avenida Fabricante
San Clemente, CA 92672 USA
+1.949.226.5222
Need an additional Charge Case or Stand?
iportproducts.com
012517
">