P980-077 L LED Ceiling Mount Fixture Installation instructions

INSTALLATION INSTRUCTIONS FOR P980-077-L

For LED Ceiling Mount Fixture

W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .

980`

A V E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D O D I S J O N C T E U R .

PREPARATION

1. Shut off power at the circuit breaker and remove the old fixture, including the mounting hardware.

2. Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration. Puts on the gloves which included in the carton to prevent the hands being hurt by

the steel mesh.

3. Position mounting plate (C) on the ceiling, and mark the location of the three drywall anchors (A).

Pre-drill the holes for the drywall anchors (A). Insert the drywall anchors (A) into the ceiling.

4. Attach the mounting plate (C) to the junction box using the two mounting screws (D) (Size:

8-32*1/2’’L) and wood screws (E). The side of the mounting plate marked “GND” must face out.

CONNECTING THE WIRES

5. Connect the electrical wires as shown in Fig.2, making sure that all wire nuts are secured. If your outlet has a ground wire (green or bare copper), connect the fixture's ground Wire to it. Otherwise, connect the fixture's ground wire directly to the mounting plate (C) using the green screw provided.

Tuck the wire connections neatly into the junction box.

FINISHING THE INSTALLATION (Fig. 1)

6. Align fixture (G) to mounting plate (C) and secure with screws (B).

7. Hang the crystal strands (H) through the loops on fixture (G). (Note: A total of 76pcs crystal strands are included).

8. Align cage (J) to fixture (G), make sure the screws

(I) on cage (J) protrude through the holes on fixture

(G) and then secure with finials (F).

Your installation is now complete. Return power to the junction box and test the fixture.

CAUTION /ATTENTION: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base or ceiling plate (G) only.

Notice

Due to the techniques used in manufacturing of this product, small tooling marks may be visible on the outside of the shade where it is attached to the support frame. All products are inspected to ensure they adhere to our quality control standards.

IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation.

Dimmable with ELV and/or LED compatible wall dimmer switches.

Fig.1

Fig.2

Set:A-021-256D

Mounting plate

Green screw

Wood screw(2)

Plastic drywall anchors(2)

Mounting screw(2)

Fig.1-1

Replacing LED module (Fig. 3)

The LED module can be replaced by a qualified electrician without cutting of wire and without damage to any decorative element to which the fixture is attached.

See installation steps for more details (Fig 3.).

Warning: Turn off power at the circuit breaker

before replacing LED module or LED driver. a. Loosen the finials (F) to remove cage (J) from fixture (G). And then remove all crystal strands (H). b. Loosen hex nuts (Q) to remove metal panel (P). c. Loosen hex nuts (O) and plastic gaskets (M) to remove LED module (L) carefully. d. Reverse steps a-c for installing the new LED module. e. Note: The LED module should be provided by a specified supplier. f. For better heat dissipation the LED module should be applied with thermal grease when re-lamping.

Fig 3

II 747