287 3 us~v~Specification Sheet
HEAT RECOVERY VENTILATOR
Venmar E15 ECM HRV
Part no. 43901
80 to 157 CFM (0.4 in. w.g.)
66 to 132 CFM (0.4 in. w.g.)
Controls
53 to 106 CFM (0.4 in. w.g.)
40 to 80 CFM (0.4 in. w.g.)
• This unit is very simple to operate. Once the unit is installed, press on
its push button, located under the unit, to activate it. Press once for
low speed, once again for high speed, and once more to stop it.
• For more convenience, this unit can also be controlled by an optional
main control. For a complete list of optional main and auxiliary
controls available, refer to the Wall Control Compatibility Chart
on last pages of wall controls specification sheet, available at
www.venmar.ca.
• For more details about controls, refer to the Main and auxiliary wall
controls user guide, also available at www.venmar.ca.
Options
• Complete line of registers and diffusers
• Electric duct heater
VB0210
DISCOVER THE NEW GENERATION OF VENMAR AIR EXCHANGERS:
ULTRA-EFFICIENT AND ENVIRONMENTALLY-FRIENDLY
The E15 ECM HRV has been designed to be one of the most
eco-friendly HRV air exchangers on the market. Its
innovative design incorporates extremely high performance
ECM* motors, which enable the E15 ECM HRV to significantly
lower energy costs without affecting its performance. Additional
energy efficiency is achieved through its advanced heat recovery core,
which can retain up to 80% of the home’s heating. The E15 ECM HRV
surpasses energy-saving standards while providing effective heat
recovery, ventilation and quiet operation. All aspects have been
designed to facilitate balancing of air flow and simplify uses and
installation.
• High performance ECM* motors
• Faster and easier installation of insulated flexible ducts with
practical straps
• Integrated balancing dampers
• Integrated electronic board on motors
• Homeshield™ defrosting system
• Heat recovery core with superior capacity
• Optimized drainage system
• ENERGY STAR® qualified
REPAIRS AND MAINTENANCE
The E15 ECM HRV high output ECM* motors are permanently
lubricated. The electronic circuit board eliminates electromechanical
parts, reducing repair time to a minimum.
WARRANTY
The E15 ECM HRV unit is protected by a complete 5-year warranty
on all parts. The heat recovery core is covered by a limited lifetime
warranty, with the original proof of purchase.
*Electronically Commutated Motor.
Available at:
Homeshield™ Defrosting System
The E15 ECM HRV uses a unique defrosting method. No negative
pressure is created by air exhausted to the outside, as the air is
recirculated into the house, helping to prevent any backdraft.
STALE AIR
FILTERED AIR
FROM BUILDING
TO BUILDING
OUTSIDE TEMPERATURE DEFROST CYCLE MIN./
°C
°F
OPERATING MIN.
WARMER
WARMER
NO DEFROST
THAN -5
THAN 23
-5 TO -15 23 TO 5
7/25
-15 TO -27 5 TO -17
7/25
- 27
-17
10/22
AND LESS
AND LESS
VF0046
Heat Recovery Core
Dimensions: 10” x 10” x 14.25” (25.4 cm x 25.4 cm x 36.2 cm)
Exchange surface: 110 ft.2 (10.2 m2)
Weight: 7.36 lb. (3.3 kg)
Material: Polypropylene
Type: Cross Flow
Warranty: Limited lifetime
Requirements and standards
• Complies with the UL 1812 requirements regulating the installation
of Heat Recovery Ventilators
• Complies with the CSA C22.2 no. 113 Standard applicable to ventilators
• Complies with CSA C444 requirements regulating the installation of
Heat Recovery Ventilators
• Technical data was obtained from published results of tests relating
to CSA C439 Standards
• HVI certified and ENERGY STAR® qualified
DIMENSIONS: E15 ECM HRV
23 9/16”
(599 mm)
2 ¹/16”
(53 mm)
3 13/16”
(97 mm)
24 9/16”
(624 mm)
1
3 FT.
22 ½”
(572 mm)
3
MINIMUM OF
7 7/16”
(189 mm)
6” DIAMETER,
BUT IF NEED
BE, THEY CAN BE CONNECTED TO BIGGER
SIZED DUCTS BY USING AN APPROPRIATE
TRANSITION
4
2
(E.G.: 6”
DIAMETER TO
DIAMETER TRANSITION).
7”
NOTE: Every port fits 6” round duct.
18 ¼”
(464 mm)
1: EXHAUST AIR TO OUTSIDE PORT
2: FRESH AIR FROM OUTSIDE PORT
14 15/16”
(380 mm)
VK0066A
UNITS PORTS WERE CREATED TO
BE CONNECTED TO DUCTS HAVING A
POWER CORD
14 1/16”
(358 mm)
NOTE: ALL
3: EXHAUST AIR FROM BUILDING PORT
4: FRESH AIR TO BUILDING PORT
EXTERNAL
STATIC PRESSURE
PA
IN. W.G.
25
0.1
50
0.2
75
0.3
100
0.4
125
0.5
150
0.6
175
0.7
200
0.8
225
0.9
250
1.0
275
1.1
NET SUPPLY
AIR FLOW
SUPPLY
L/S
CFM
M3/H
L/S
CFM
89
83
79
74
69
64
59
54
47
40
35
189
177
167
156
147
136
126
115
110
86
74
320
299
284
266
248
230
212
194
169
144
126
89
84
79
74
69
64
60
54
47
41
35
190
179
169
158
148
137
127
116
101
87
75
GROSS AIR FLOW
EXHAUST
M3/H
L/S
CFM
320 87 185
302 83 177
284 79 167
266 73 155
248 68 146
230 63 133
216 58 123
194 51 108
169 45
96
148 38
80
126 31
65
M3/H
313
299
284
263
245
227
209
184
162
137
112
EXTERNAL STATIC PRESSURE
(IN. W.G.)
VENTILATION PERFORMANCE
1.2
Supply
Exhaust
1.0
0.8
0.6
0.4
0.2
4
0.0
0
VG0083A
NET AIR FLOW
POWER
SENSIBLE
APPARENT
LATENT RECOVERY/
CONSUMED
RECOVERY
SENSIBLE
MOISTURE
L/S
CFM
M3/H
WATTS
EFFICIENCY
EFFECTIVENESS
TRANSFER
23
30
38
57
29
49
64
81
122
61
83
109
138
207
104
24
26
32
54
40
75
74
73
67
64
83
80
78
72
89
0.01
0.01
0.01
0.01
0.02
50
75
3
100
2
125
1
150
175 200
GROSS AIR FLOW (CFM)
SPEED RANGE* 1: 80 TO 157 CFM
SPEED RANGE* 2: 66 TO 132 CFM
SPEED RANGE* 3: 53 TO 106 CFM
SPEED RANGE* 4: 40 TO 80 CFM
*AT 0.4 IN. W.G.
ENERGY PERFORMANCE
SUPPLY
TEMPERATURE
°C
°F
HEATING
0
32
0
32
0
32
0
32
-25 -13
25
NOTE: All specifications are subject to change without notice.
SPECIFICATIONS
• Model: E15 ECM HRV
• Part Number: 43901
• Total Assembled Weight (including
polypropylene core): 52.4 lb. (23.8 kg)
• Oval shaped ports; fit 6” round ducts
• Drains: 1/2” (1.2 cm) fittings with
10 ft (3 m) PVC drain
• Core Filters: 2 washable Merv 9 filters,
9.2” x 14.25” x 0.38”
(23.4 cm x 36.2 cm x 1 cm)
Project:
Location:
Part no.: 43901
Qty.:
Submitted by:
• Insulation: Expanded polystyrene
• Heat Recovery Core:
• Mounting: Suspension by chains and springs - Heat Exchange Surface Area: 110 ft.2 (10.2 m2)
• Supply and Exhaust Blower Motors:
- Type: Crossflow
2 ECM motors
- Material: Polypropylene
- Protection type: Thermally protected
• Housing: Pre-painted steel
- Insulation class: B
• Speed Control on Unit:
- Low speed and high speed
• Unit Electrical Characteristics:
- Other modes available with Altitude
Volts Frequency Ampere Watts
or Deco-Touch main control
120
60 Hz
1.3
98
REMARKS
Date:
Residential Products Group, 550 Lemire Blvd., Drummondville, Qc, Canada J2C 7W9 - Tel.: 1-800-567-3855 Fax: 1-800-567-1715
www.venmar.ca
AVSE15ECMHRVd151014
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement