Aqua Lung Reflector Kit Installation instructions

PN 427047
0
53242 18088
7
Reflector Ring
Installation Instructions
1. Unscrew valve cap (1).
2. Place reflector ring (2) over threads (3).
3. Properly position spring inside valve: Wide end of
spring fits in recessed hole on inside of cap; small
end of spring fits over small boss on valve plate (4).
While pulling on cord to keep spring in place,
thread valve cap onto BC.
4. Fully inflate BC. Test dump valve by pulling on
string. Re-inflate BC. Let stand for 30 minutes.
BC should remain inflated.

„
ƒ
‚
Reflector Patch
Note: Reflector patch is normally place above inflator
hold-down. On some smaller BCs, it must be attached
below hold-down.
1. Before installing reflector, attach low-pressure
inflator hose (1).
2. Disconnect inflator hold-down and lift up corrugated hose (2).
3. Reflector patch is secured with “sandwich-style”
hook & loop attachment. Place reflector against
hose. Wrap inside hook flap (3) around inflator
hose. Secure loop flap (4) to hook flap. Secure
outer hook flap (5) to loop flap.
…
ƒ

‚
„
Literature PN 18319, Rev 7/2004