285 3 us~v~Specification Sheet

285 3 us~v~Specification Sheet
HEAT RECOVERY VENTILATOR
Venmar AVS E15 HRV
Part no. 43135
65 to 155 CFM (0.4 in. w.g.)
Controls
• This unit is very simple to operate. Once it is installed, press on its
push button, located under the unit, to activate it. Press once for low
speed, once again for high speed, and once more to stop it.
• For more convenience, this unit can also be controlled by an optional
main control. For a complete list of optional main and auxiliary
controls available, refer to the Wall Control Compatibility Chart
on last pages of wall controls specification sheet, available at
www.venmar.ca.
• For more details about controls, refer to the Main and auxiliary wall
controls user guide, also available at www.venmar.ca.
Options
• Complete line of registers and diffusers
• Electric duct heater
VB0211
THE LAST ARRIVAL IN OUR NEW E SERIES
This new model is designed to provide a superior heat recovery,
meeting the highest requirements of energy-efficient home programs.
By getting more points from it’s category in the builder option
packages*, it represents a cost-effective solution for efficent home
contractors.
The E15 HRV offers all the basic features for the new
construction market, such as integrated balancing dampers
and a defrosting system without negative pressure. Moreover, all aspects
of its design were thought to ease balancing of air flow and simplify
installation; it also offers easy access to electronic components.
This unit does not only improve the indoor air quality, it also lowers the
customer’s energy bills while bringing added value to the contractor.
Homeshield™ Defrosting System
The E15 HRV uses a unique defrosting method. No negative
pressure is created by air exhausted to the outdoors, as the air is
recirculated into the house, helping to prevent any backdraft.
STALE AIR
FILTERED AIR
FROM BUILDING
TO BUILDING
OUTSIDE TEMPERATURE DEFROST CYCLE MIN./
°C
°F
OPERATING MIN.
WARMER
WARMER
NO DEFROST
THAN -5
THAN 23
-5 TO -15 23 TO 5
5/40
-15 TO -27 5 TO -17
5/25
- 27
-17
8/22
AND LESS
*Applies to certain energy-efficient building programs.
• Features pressure taps, balancing dampers and port straps to
simplify installation
• Easy to access electronic module
• Homeshield™ defrosting system (no negative pressure)
• Heat recovery core offers greater comfort
• Designed with 2 PSC high-pressure blowers
• Integrated draining system
• ENERGY STAR® qualified
REPAIRS AND MAINTENANCE
The E15 HRV’s low power consumption PSC motors are
permanently lubricated. The electronic circuit board eliminates
electromechanical parts, reducing repair time to a minimum.
WARRANTY
The E15 HRV is protected by a 5-year warranty on parts only,
except for the heat recovery core, which is covered by a limited lifetime
warranty, with the original proof of purchase.
Available at:
AND LESS
VF0046
Heat Recovery Core
Dimensions: 10” x 10” x 14.25” (25.4 cm x 25.4 cm x 36.2 cm)
Exchange surface: 100 ft.2 (9.3 m2)
Weight: 7.26 lb. (3.3 kg)
Material: Polypropylene
Type: Cross flow
Warranty: Limited lifetime
Requirements and standards
• Complies with the UL 1812 requirements regulating the installation
of Heat Recovery Ventilators
• Complies with the CSA C22.2 no. 113 Standard applicable to ventilators
• Complies with CSA C444 requirements regulating the installation of
Heat Recovery Ventilators
• Technical data was obtained from published results of tests relating
to CSA C439 Standards
• HVI certified and ENERGY STAR® qualified
DIMENSIONS: E15 HRV
23 9/16”
(599 mm)
2 ¹/16”
(53 mm)
3 13/16”
(97 mm)
24 9/16”
(624 mm)
1
3 FT.
22 ½”
(572 mm)
UNITS PORTS WERE CREATED TO
BE CONNECTED TO DUCTS HAVING A
3
7 7/16”
(189 mm)
POWER CORD
MINIMUM OF
6” DIAMETER,
BUT IF NEED
BE, THEY CAN BE CONNECTED TO BIGGER
SIZED DUCTS BY USING AN APPROPRIATE
4
2
TRANSITION
(E.G.: 6”
DIAMETER TO
DIAMETER TRANSITION).
7”
NOTE: Every port fits 6” round duct.
18 ¼”
(464 mm)
14 1/16”
(358 mm)
1: EXHAUST AIR TO OUTSIDE PORT
2: FRESH AIR FROM OUTSIDE PORT
14 15/16”
(380 mm)
VK0066A
NOTE: ALL
3: EXHAUST AIR FROM BUILDING PORT
4: FRESH AIR TO BUILDING PORT
VENTILATION PERFORMANCE
NET SUPPLY
AIR FLOW
SUPPLY
L/S
CFM
M3/H
L/S
CFM
93
86
80
73
66
59
51
43
34
26
198
183
169
155
139
124
107
91
73
54
336
311
287
263
236
211
182
155
124
92
94
87
80
73
66
59
51
43
35
26
199
184
170
156
140
124
108
92
74
55
GROSS AIR FLOW
EXHAUST
M3/H
L/S
CFM
338 96 204
313 91 192
289 85 180
265 79 167
238 73 154
211 66 139
183 59 125
156 52 110
126 46
97
93
39
83
1.0
M3/H
347
326
306
284
262
236
212
187
165
141
EXTERNAL STATIC PRESSURE (IN. W.G.)
EXTERNAL
STATIC PRESSURE
PA
IN. W.G.
25
0.1
50
0.2
75
0.3
100
0.4
125
0.5
150
0.6
175
0.7
200
0.8
225
0.9
250
1.0
0.9
0.8
0.7
0.6
0.5
0.4
0.3
SUPPLY
EXHAUST
0.2
0.1
VG0096A
0 15 30 45 60 75 90 105 120 135 150 165 180 195 210
GROSS AIR FLOW (CFM)
ENERGY PERFORMANCE
SUPPLY
TEMPERATURE
°C
°F
HEATING
0
32
0
32
0
32
-25 -13
NET AIR FLOW
POWER
SENSIBLE
APPARENT
LATENT RECOVERY/
CONSUMED
RECOVERY
SENSIBLE
MOISTURE
L/S
CFM
M3/H
WATTS
EFFICIENCY
EFFECTIVENESS
TRANSFER
31
40
55
30
65
84
116
64
110
143
197
109
54
66
90
72
75
73
69
73
83
80
76
84
0
0
0
0.05
NOTE: All specifications are subject to change without notice.
SPECIFICATIONS
• Model: E15 HRV
• Part Number: 43135
• Total Assembled Weight (including
polypropylene core): 52 lb. (23.6 kg)
• Oval shaped ports; fit 6” round ducts
• Drain: 1/2” (1.2 cm) integrated fittings with
10 ft. (3 m) PVC drain hose
• Core Filters: 2 washable Merv 7 filters,
9.2” x 14.25” x 0.38”
(23.4 cm x 36.2 cm x 1 cm)
Project:
Location:
Part no.: 43135
Qty.:
Submitted by:
•
•
•
•
Housing: Pre-painted steel
• Speed Control on Unit:
Insulation: Expanded polystyrene
- Low speed and high speed
Mounting: Suspension by chains and springs - Other modes available with Altitude,
Supply and Exhaust Blower Motors:
Deco-Touch or Lite-Touch Constructo
2 PSC motors
main controls
- Protection type: Thermally protected
- Insulation class: F
• Heat Recovery Core:
• Unit Electrical Characteristics:
- Heat Exchange Surface Area: 100 ft.2 (9.3 m2)
Volts Frequency Ampere Watts
- Type/Material: Crossflow/Polypropylene
120
60 Hz
1.0
125
REMARKS
Date:
Residential Products Group, 550 Lemire Blvd., Drummondville, Qc, Canada J2C 7W9 - Tel.: 1-800-567-3855 Fax: 1-800-567-1715
www.venmar.ca
AVSE15HRVd151014
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement