null  null
2560 x 2048
211 FPS
SP-5000-CXP2
5-megapixel CMOS global shutter
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
ƒ
Large format 5 MP CMOS imager (global shutter)
Up to 211 fps at full resolution
5.0 μm square pixels in a 5:4 aspect ratio
60 dB linear dynamic range with up to 100 dB piece-wise HDR modes
Analog and digital gain control for less quantized noise in low-light situations
Exposure control from 10 μs (1/100,000) to 8 seconds in 1 μs steps
2X binning for increased sensitivity (monochrome only)
ROI modes for flexible readout, windowing, or increasing frame rate
Monochrome or color models with built-in color interpolation on color model
8/10/12-bit digital output over two-channel CoaXPress interface
Accepts power via CoaXPress or separate 12-pin connector
C-mount lens mount
Automatic Level Control (ALC) for dynamic lighting conditions
Programmable P-iris lens control or 3-axis control for operation of motorized lenses,
pan/tilt heads, or other analog accessories
www.jai.com
W W W. S T E M M E R- I M A G I N G . C O M
Spark Series
Spark Series
Specifications for SP-5000-CXP2
Gamma
Synchronization
Trigger input
Trigger modes
Ordering Information
Monochrome camera with two-channel CoaXPress
Color camera with two-channel CoaXPress
0 'HSWK
ȭ
0 'HSWK
& 0RXQW
*Traditional SNR is based on random noise in a single frame, where EMVA SNR measurements
consider more comprehensive noise sources and variance over time. For a more complete
description, see the manual.
LINK-1
CXP-1 CXP-2
LINK-2
0 'HSWK
Connector pin-out
DC In / Trigger
CoaXPress Interface
CXP-1
Asia Pacific
Phone +81 45 440 0154
Fax +81 45 440 0166
CXP-2
HIROSE HR10A-10R-12PB-01
One- or two-channel output
Requires cable(s) with 75Ω
1.0/2.3 DIN-type connector
Supports up to 6.25 Gbps per channel
Power can be supplied on channel #1
Connector Pin-out
Pin 1 GND
2 +12V to +24V DC input
3 GND
4 NC
5 Opto In6 Opto In+
7 Opto Out8 Opto Out+
9 TTL out 1
10 TTL in 1
11 +12V to +24V DC input
12 GND
Spectral Response
0.7
0.6
0.5
0.4
0.3
0.2
0.1
0
400
500
600
700
Wavelength (nm)
Note: Color response includes IR-cut filter.
†Reduced performance may occur when operating outside the standard range of -5°C to +45°C
Americas
Phone (Toll-Free) 1 800 445 5444
Phone +1 408 383 0300
Visit our web site on www.jai.com
Imaging is our passion.
www.stemmer-imaging.com
DC IN / TRIG
AUX
Monochrome –
Red –
Green –
Note: Add-CX to model number for adjustable c-mount.
Europe, Middle East & Africa
Phone +45 4457 8888
Fax +45 4491 3252
POWER/ TRIG
10-bit output format
23.50 p (h = 525 nm)
36.08 p h = 525 nm)
41.48 dB
38.00 dB
>55 dB (0 dB gain)
>53 dB (0 dB gain, green)
8/10/12-bit monochrome
8/10/12-bit Bayer or 24-bit RGB
0.7Vp-p, with 0.3V horiz. sync
Manual/automatic 0 dB to +24 dB
Manual, one-push auto, or continuous
(3000K to 9000K)
0.45-1.0 (16 steps) or 256-point LUT
Internal
TTL, CXP, Pulse Generators (4), Software,
NAND Out (2), GPIO
EPS, PIV, Trigger Width, Timed RCT (with ALC),
Sequence
Electronic shutter
Timed exposure
10 μs to 8 sec in 1 μs steps
Auto shutter
1/211 to 1/100000 sec.
Auto Level Control (ALC)
Shutter range from 1/211 to 1/100000, gain range
from 0 dB to +24 dB, auto iris control
Tracking speeds and max values adjustable.
Pre-processing functions
&LATÎjELDÎCORRECTIONÎCOLORÎSHADINGÎCORRECTIONÎ
(SP-5000C), blemish compensation (512 pixels)
3-axis control
Programmable control of motorized lenses,
pan/tilt heads, and other analog accessories
Operating temperature
-45°C to +70°C†
Storage temperature
-45°C to +70°C
Humidity
20 - 80% non-condensing
Vibration
10 G (20Hz to 200Hz XYZ)
Shock
80 G
Regulations
CE (EN61000-6-2, EN61000-6-3),
FCC Part 15 class B, RoHS/WEEE
Power
12V to 24V DC ± 10%. 5.9-6.8W typical
(full frame @ 12V)
Lens mount
#MOUNTÎjXEDÎORÎADJUSTABLE
Dimensions (H x W x L)
62 mm x 62 mm x 55.5 mm
Weight
215 g
SP-5000M-CXP2
SP-5000C-CXP2
STEMMER IMAGI NG Head Office
Gutenbergstraße 9 - 13, D-82178 Puchheim
Phone: +49 89 80902-0, [email protected]
Blue –
800
900
1000
K-JAIO53-01/2015 ∙ Subject to technical change without notice. No liability is accepted for errors which may be contained in this document.
Binning
Color interpolation
(SP-5000C)
EMVA 1288 Parameters
Absolute sensitivity (mono)
Absolute sensitivity (color)
Maximum SNR (mono)
Maximum SNR (color)
Traditional SNR*
mono
color
Video signal output
mono
color
Auto-iris lens video output
Gain
White balance (SP-5000C)
Full
ROI
1” CMOS global shutter
72/57.6/48 MHz selectable
211 frames/sec. @ 8-bit
12.8 mm (h) x 10.2 mm (v), 16.39 mm diagonal
5.0 μm (h) x 5.0 μm (v)
2560 (h) x 2048 (v)
2560 (h) x 2048 (v) up to 211 fps
Any start line, any height in 1 line steps, with
X offset and width in 64 pixel steps
1x2, 2x1, 2x2 (monochrome only)
24-bit RGB output at 44 fps
Sensitivity (relative QE x FF)
Sensor
Pixel clock
Frame rate, full frame
Active area
Cell size
Active pixels
Read-out modes
Dimensions
SP-5000-CXP2
Specifications
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement