Dometic | 3313193 | 10/26/10 3313192 3313193 3313194 SZLCD Thermostat User`s

10/26/10 3313192 3313193 3313194 SZLCD Thermostat User`s
Fan Mode Setting
1. Press and release the On/Off Mode button. Press and
release the “+” or “―” button to cycle through the fan
speed options (Lo (Low), Hi (High), Au (Auto)).
Fan
Cool
Furnace
On/Off
Mode
Mode of Operation
Fan
Cool
Furnace
˚F
On/Off
Mode
A mode is an operation that can be performed by the
Dometic Single Zone LCD Thermostat.
2. Press and release the On/Off Mode button to cycle
through the available modes. All Dometic Single Zone
LCD Thermostats have Cool and Furnace modes. Select
models will have an additional mode, either Heat Pump
or Heat Strip. When desired mode has been selected, the
LCD will display the temperature set-point and the green
LED will be lit next to the selected mode.
Single Zone LCD Thermostat
User’s Guide
Dometic Single Zone LCD Thermostat Quick Start-Up
The basic steps for operating your Air Conditioner or Heat Pump are described in
this User’s Guide. For more detailed information on modes of operation and special
features refer to the Operating Instructions Manual.
Quick reference to control buttons
To change the set-point, press the “+” button to increase
the set point and the “―” button to decrease the set-point.
Indicates mode of operation
when illuminated
Inside Temperature
Fan
Cool
Furnace
˚F
Press to increase
temperature set-point
3. To display the Inside Temperature, the Single Zone LCD
thermostat must be in the OFF Mode. Press either the “+”
or “―” button to display the Inside Temperature.
On/Off
Mode
Special Features:
• Auto Fan
See Operating Instructions for more
Information on this special feature.
LCD Error Code
When the system determines that one
of the faults listed below has occurred
an error code will be displayed in the
LCD.
In the unlikely event you experience a
system failure, refer to the “SERVICE”
section of the Operating Instructions
furnished with your unit.
Fan
Cool
Furnace
Error Code:
E1 Loss of communication between the Single Zone LCD
thermostat and module board. LCD will cycle between E1
and previous mode setting. System will shut down.
E2 Open circuit or out of range Indoor Temperature Sensor.
Heating and cooling operation will be locked out. Fan operation can continue to operate.
E3 Shorted Indoor Temperature Sensor. Heating and cooling
operation will be locked out. Fan operation can continue
to operate.
E4 Open circuit or out of range Outdoor Temperature Sensor
(Select Models). Heat pump will be locked out. Air conditioner, furnace, and fan mode of operation can continue
to operate.
E5 Open circuit or out of range Freeze Sensor. Air conditioner mode of operation will be locked out. Furnace, heat
strip, heat pump, and fan mode of operation can continue
to operate but displays the last temperature set-point.
*Heat
Pump or
Heat Strip
* Select models
USA
SERVICE OFFICE
Dometic, LLC
2320 Industrial Parkway
Elkhart, IN 46516
574-294-2511
˚F
On/Off
Mode
Press to select
mode of operation
Press to decrease
temperature set-point
CANADA
Dometic, LLC
46 Zatonski, Unit 3
Brantford, ON N3T 5L8
CANADA
519-720-9578
3313325.031
For Service Center
Assistance Call:
800-544-4881
REVISION
Form No. 3313325.031 10/10
(French 3313326.039)
©2010 Dometic, LLC
LaGrange, IN 46761
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising