MB QUART QUB2.10201 Quick Start Guide

Add to my manuals
12 Pages

advertisement

MB QUART QUB2.10201 Quick Start Guide | Manualzz

QUBTwo

Bluetooth

TM

Speaker

Page 3

4

5

6-7

10

11

8

9

Important Safety Instructions

Controls

Charging

Bluetooth Connection

Auxiliary Input

Receiving and Making Calls

Specifications

Warranty

CONTENTS

IMPORTANT SAFETY INSTRUCTIONS

• Read, follow and keep these instructions.

• Do not use this product near water or wet surfaces.

• Clean only with a dry cloth.

• Do not expose to extreme high or low temperatures.

• Only use the supplied cables for charging and playback.

3

Volume Up \ Down

Function Button

4

Power Switch

CONTROLS

Pairing LED

CHARGING

The first time you use your Bluetooth speaker, please charge it for at least 3 hours. During the first charge, do not turn on the device.

Using the supplied USB cable connect to a USB power source

(eg. a computer).

While charging, the power switch on the side of the unit will turn red.

When fully charged, the power switch light will turn off.

After the first charge, you can play and charge at the same time.

5

BLUETOOTH CONNECTION

When the speaker is turned on, you should hear a beep and the pairing LED on the front of the speaker will flash indicating that pairing mode is activated and it is searching for a

Bluetooth source.

Go to the Bluetooth menu of your source device and connect to QUBTwo from the list of devices. If asked for a code, enter 0000.

Once the connection is achieved, the pairing LED will stop flashing and the speaker will emit two short beeps.

You are now connected and can play from your source.

6

TROUBLE CONNECTING?

Make sure that no other source in range is connected. Only one connection can be made at a time, The speaker may automatically connect to a source it has been paired with in the past.

Turn off the speaker, then on again. Try pairing again.

Make sure the source is Bluetooth compatible and that the Bluetooth is activated.

Review your source device documentation for Bluetooth pairing instructions.

7

8

AUXILIARY INPUT CONNECTION

Insert the supplied 3.5mm cable into the speaker’s AUX input.

Connect the other end to the output of your source device.

The power switch light will turn off.

You can now play your content.

The Bluetooth will be disabled anytime a 3.5mm cable is inserted into the AUX input.

RECEIVING AND MAKING CALLS

Your speaker will allow you to make hands free calls provided your phone is connected via Bluetooth.

The AUX connection cannot be used for this function.

To make a call: Use the phone as normal, select the Bluetooth speaker when prompted.

To receive a call: Either push the FUNCTION button on the top of the speaker or answer the call with the phone making sure to select the Bluetooth speaker when prompted.

Ending a call: Either push the FUNCTION button on the top of the speaker or hang up using the phone as you normally would.

Rejecting a call: Push the FUNCTION button for three seconds.

To switch from the Bluetooth speaker to the phone during a call: Press the FUNCTION button twice.

9

Active Drivers:

Passive Drivers:

Amplifier Power:

Frequency Response:

Battery Type:

Battery Capacity:

2 - 40mm (1.57 Inches)

1

6 Watts

75Hz - 17KHz

Lithium-ion Polymer

1050mAh

10

SPECIFICATIONS

Play Time:

Recharge Time:

Bluetooth Profiles:

Bluetooth Range:

Dimensions:

Weight:

6 to 8 Hours

3.0 Hours

HFP-A2DP/ARVCP

10 meters in open space

62 x 110 x 72 (mm)

270 grams

WARRANTY

Maxxsonics USA Inc. warrants this product, to the original consumer purchaser, to be free from defects in material and workmanship for a period of one (1) year from the date of purchase.

Maxxsonics USA Inc. will, at it’s discretion, repair or replace defective products during the warranty period. Components that prove to be defective in materials or workmanship must be returned to the original authorized Maxxsonics USA Inc. retailer from where it was purchased. A photocopy of the original receipt must accompany the product being returned. This warranty is limited to defective parts and specifically excludes any incidental or consequential damages connected therewith. To view the full warranty, please visit the website.

The Bluetooth™ word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by MB Quart is under license.

11

MBQuart products are designed and engineered in the USA by

847-540-7700 www.maxxsonics.com

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement