Winnebago Adventurer Basic Operation Manual

DVD HOME THEATER

SYSTEM

–If Equipped

The available DVD home theater system operates from 120-volt AC household current only, so you must have either the shoreline connected, the generator running, or the inverter turned on (if equipped).

The TV is connected to the Home

Theater System which plays through theater speakers in the lounge area of the coach.

Connect

Theater

Speakers

• Press the

SPEAKERS switch on the dash to TV position to connect the theater speakers to the

Home Theater system.

NOTE:The Aux. Battery Disconnect switch must also be on while listening to Theater Sound because the audio relay is powered by house batteries. If the Aux Batt switch is off, the speakers will not emit any sound.

Set TV Video Input

• Turn On both

TV and DVD player

• Press TV/

VIDEO or

INPUT button on the remote or front of TV and select

“Video 1” input on the

TV.

The TV screen will display the DVD player logo when the correct input is selected.

Play DVD with Theater

Sound

• Insert DVD into player. DVD will begin to ‘load’ automatically. TV screen will typically show

“READING” or “LOADING.”

• The DVD may load directly to the main title/menu screen or it may begin to play previews. You may be able to skip previews if desired by pressing the ‘NEXT’ button until you see the main menu screen.

• When the main menu screen appears, use the arrow buttons on the remote to select the desired entry or press the

ENTER or PLAY buttons on the remote (or ‘Play’ button on DVD player) to begin playing the feature.

• Volume is adjusted with the DVD remote (or volume control on DVD player).

TV Sound through Home

Theater Speakers

When watching TV programs

(broadcast, cable or satellite), the TV normally plays sound through its own built-in stereo speakers. To connect TV sound output to home theater speakers for a richer sound quality, follow these steps:

• Press SPEAKERS switch on dash to

TV position.

• Turn the TV and DVD player On.

• Select the TV channel you wish to watch.

• Press FUNCTION button on DVD player or remote to set DVD player to

“AV IN.”

• Use the TV Menu button to set TV audio output to ‘Variable Audio

Output.’ (See TV owner’s manual

Continued—

for instructions.) This will route TV stereo sound output through the home theater system.

• Select TV channels and adjust theater speaker volume with remote for either the TV or DVD.

Dash Radio Sound through

Home Theater Speakers

–If Equipped

See “Radio – In-Dash” in Section 3.

Part No. 161501-08-020

0801080211

Copyright 2007 Winnebago Industries, Inc.

All rights reserved.

Audio-Video System

Basic Operation

Guide

NOTE: See your InfoCase for specific operating guides for audio and video components.