Avtec Taku Specification Sheet, Model AXSO

Avtec Taku Specification Sheet, Model AXSO
Exhaust Only Back
Shelf Ventilator for
Light and Medium Duty
Cooking Equipment
TAKU Premier Ventilation Exhaust Only Cartridge model AXSO
Description:
This is a low profile, exhaust only ventilator designed
to mount either on the wall or on a Randell equipment
stand. The AXSO model is UL 710 Listed for use over
400 and 600ºF commercial cooking appliances.
This model is recommended for 24” and 30” deep
cooking equipment and most countertop cooking
appliances. Ovens and broilers are not recommended
for use under this model.
Specifications:
Exhaust only Type I commercial kitchen ventilator. UL 710 Listed with or without a fire damper in the exhaust collar. Canopy is
constructed of a minimum 18 gauge non-magnetic stainless steel on all surfaces. Ventilator shall have all welded exterior joints
and seams and comply with NFPA 96 standards for construction. All exposed welds are to be ground and polished to match
finish requirements. Ventilator is to meet NSF standards for construction and UL standards for operation. Ventilator shall contain
UL Listed stainless steel dry extractor grease cartridges running the full length. Grease trough(s) shall be concealed and pitched
to a removable grease cup.
Standard Features:
•Non-magnetic stainless steel construction
•UL Listed stainless steel grease cartridges
•3” Rear air space
•Pre-drilled hanger brackets
•Full length concealed grease trough sloped to a removable
grease cup located at end of unit
•Exhaust collar installed
•Wall or base mount design
1055 Mendell Davis Drive, Jackson, MS 39272
888-994-7636, unifiedbrands.net
Please reference our website for the most
updated product information and specifications.
Optional Accessories:
UL Listed fusible link fire damper
Pre-plumbed fire suppression
Insulated 3” air space for 0” clearance to combustibles
Stainless steel finished back
Stainless steel top enclosures
Melink Intelli-Hood® system controls
Exhaust fan / cooking equipment interlock control
UL Listed exhaust volume damper available on
all models with (2) exhaust collars
Avtec TAKU Premier Ventilation, Page 8
PP SPEC1012 Rev. D
Revised 05/09
Model AXSO
Light Duty Temperature Cooking Equipment – 400°F
Light duty ranges, roasters, ovens, steamers, etc…
Medium Duty Temperature Cooking Equipment – 400-600°F
Rotisseries, ranges, grills, fryers, etc…
Heavy Duty Temperature Cooking Equipment – 600°F
Gas char-broilers, woks, upright broilers, etc...
Extra-Heavy Temperature Cooking Equipment – 700°F
Solid fuel broilers
Length
4’-0”
5’-0”
6’-0”
7’-0”
8’-0”
9’-0”
10’-0”
11’-0”
12’-0”
13’-0
14’-0”
15’-0”
16’-0”
400 Degree Light Duty
Cooking Equipment
Exhaust CFM
CFM @
Duct Collar
1.25”SP
900
8 x 10
1125
8 x 12
1350
8 x 16
1575
8 x 18
1800
8 x 20
2025
8 x 22
2250
8 x 26
2475
8 x 28
2700
8 x 30
2925
8 x 32
3150
8 x 36
3375
8 x 38
3600
2-8 x 20
500-600 Medium Duty
Cooking Equipment
Exhaust CFM
CFM @
Duct Collar
1.50” SP
1200
8 x 14
1500
8 x 16
1800
8 x 20
2100
8 x 24
2400
8 x 28
2700
8 x 30
3000
8 x 34
3300
8 x 38
3600
8 x 40
3900
2-8 x 22
4200
2-8 x 24
4500
2-8 x 26
4800
2- 8 x 28
600 Degree Heavy Duty
Cooking Equipment
Exhaust CFM
CFM @
Duct Collar
1.65”SP
1600
8 x 16
2000
8 x 22
2400
8 x 28
2800
8 x 32
3200
8 x 36
3600
8 x 40
4000
2-8 x 22
4400
2- 8 x 24
4800
2-8 x 28
5200
2-8 x 30
5600
2-8 x 32
6000
2-8 x 34
6400
2-8 x 36
Note: Greater exhaust air flow rates may be required for each specific installation to obtain complete vapor and smoke removal.
Note: Hoods over 15’-0”in length require two exhaust duct collars. Exhaust collar sizing is based on an average range of 1600 FPM. Duct collars are
located on centerline of canopy, unless otherwise specified. Hoods with two exhaust collars have them located on ¼ length line of the hood.
Note: 6” side overhang is not required on non-canopy style hoods. A maximum front under-hang of 12” is allowed for non-canopy style hoods.
1055 Mendell Davis Drive, Jackson, MS 39272, 888-994-7636, unifiedbrands.net
© 2009 Unified Brands. All Rights Reserved. DOVER® and the DOVER® Logo are registered
trademarks in the United States [and various other countries] of Unified Brands, a
wholly-owned subsidiary of Dover Corporation.
UMC
IMC
NFPA-96
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement