Battery Terminal Protector

Battery Terminal Protector
MATERIAL SAFETY DATA SHEET
COMPLIES WITH OSHA’S HAZARD COMMUNICATION STANDARD (29 CFR 1910.1200)
SECTION I · PRODUCT IDENTIFICATION
Product Name: Battery Terminal Protector
Product Number: 723
Product Type: AEROSOL
Supplier's Name: Terand Industries, Inc.
Supplier's Address: P.O. Box 667770, Pompano Beach, FL 33066
D.O.T. Hazard Class: CONSUMER COMMODITY · ORM-D
Formula: Proprietary
Date Prepared: 03/09/05
Emergency Phone: (800) 255-3924
Information Phone: (954) 974-5440
HMIS Rating (Based on Aerosol Conc.):
0-Minimal
1- Slight
2- Moderate
3- Serious
4- Extreme
HEALTH: 1 FIRE: 3
REACTIVITY: 0
Personal Protection: B
SECTION II · INGREDIENTS
CHEMICAL NAME
CAS #
%WT
Mineral Spirits
Isoparaffinic Hydrocarbon
8052-41-3
64741-66-8
15-25
10-20
Liquified Petroleum Gas
68476-85-7
40-60
313/Chem
Skin
Carcinogen
PEL
TWA/TLV
NO
NO
NO
NO
NO
NO
100 ppm
400 ppm
100 ppm
400 ppm
NO
NO
NO
1000 ppm
1000 ppm
SECTION III · PHYSICAL DATA
Data Below Based On Aerosol Concentrate Only:
Boiling Point: ~ 244°F
pH: N/A
Solubility In Water: Slight
Appearance/Odor: Dark Brown Liquid, Solvent Odor
Data Below Based On Total Contents:
Vapor Pressure of can (psig @70°F): 50
Total VOC %: ~ 76%
Vapor Density(Air=1): >1
Specific Gravity (H2O=1)@75°F: 0.848
SECTION IV · FIRE AND EXPLOSION DATA
Flash Point (of Concentrate Only): 67°F (T.O.C.)
Flammability (as per USA Flame Projection Test): Extremely-Flammable Spray
Extinguishing Media: Foam, CO2, Dry Media
Special Fire Fighting Procedures: Wear self-contained breathing apparatus and protective clothing. Cool fire exposed containers to prevent rupturing.
Unusual Fire and Explosion Hazards: Exposure to temperature above 120° F may cause bursting.
SECTION V · REACTIVITY DATA
Stability: Material Stable.
Incompatibility: Avoid contact with strong oxidizing agents.
Hazardous Decomposition Products: Carbon Dioxide, Carbon Monoxide.
Hazardous Polymerization: Will not Occur.
SECTION VI · STORAGE AND HANDLING
KEEP OUT OF REACH OF CHILDREN.
For Industrial and Institutional use only.
Store in a cool, dry area away from heat or open flame.
Do not store at temperatures above 120° F.
NFPA Code 30B Rating: Level 3 Aerosol.
SECTION VII · HEALTH AND FIRST AID
PRIMARY ROUTES OF ENTRY & EFFECTS OF OVER EXPOSURE:
Eyes: May cause slight irritation but does not injure eye tissue.
Skin: Frequent or prolonged contact may cause irritation.
Inhalation: Inhalation of mist can cause irritation of nasal and respiratory passages. Abusive or excessive inhalation may cause irritation to the upper respiratory tract,
dizziness, nausea and other central nervous system effects.
Ingestion: Can cause gastrointestinal irritation, nausea, vomiting and diarrhea. Aspiration of material into the lungs can cause chemical pneumonitis..
FIRST AID PROCEDURES:
Eyes: Flush with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open. If irritation persists get medical attention immediately.
Skin: Wash with soap and water. If irritation persists seek medical attention.
Inhalation: Remove to fresh air. Seek medical attention immediately. If breathing stops give artificial respiration.
Ingestion: Do not induce vomiting. Seek medical attention immediately.
SECTION VIII · SPECIAL PROTECTION DATA
Respiratory Protection: None needed for proper use in accordance with label directions.
Ventilation: Provide local exhaust to keep TLV of Section II ingredients below acceptable limits.
Protective Gloves: None needed for proper use in accordance with label directions. Use chemical resistant gloves if hand contact will be made.
Eye Protection: None needed unless it is anticipated that a splash or spray back will occur, then wear safety glasses or chemical proof goggles.
SECTION IX · SPILL OR LEAK PROTECTION
STEPS TO BE TAKE IN CASE OF SPILL OR LEAK: Allow propellant to evaporate. Maintain local exhaust and adequate ventilation. No smoking. Keep sparks, heat
sources and open flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose of soaked absorbent material in
accordance with Federal, State and local laws.
WASTE DISPOSAL METHOD: Aerosol cans, when emptied and depressurized through normal use, pose no disposal hazard and should be recycled. Consult Federal,
State and local authorities for approved procedures.
N/A= NOT APPLICABLE · N/E=NOT ESTABLISHED · N/D=NOT DETERMINED · <=LESS THAN · >=MORE THAN
NOTICE: The information contained on this Material Safety Data Sheet is considered accurate as of the date of publication. It is not necessarily all inclusive nor fully adequate in every circumstance. The
suggestions should not be confused with, nor followed in violation of applicable laws, regulations, rules or insurance requirements. No warranty, express or implied, of merchantability, fitness, accuracy
of data, or the results to be obtained from the use thereof is made. The vendor assumes no responsibility for injury or damages resulting from the inappropriate use of this product.
RELEASED Version
©Toro 2007-2007
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement