- No category
advertisement
▼
Scroll to page 2
of 11
Software Upgrade Installation manual • Download the latest version of software, found on the website http://hp.danfoss.net under products. Save this file on your computer. • Download the latest version of Java, www.java.com. • Connect your PC to the WM HPC by using a crossover network cable. Connect the network cable to the port marked Ethernet on the WM HPC. If your PC and WM HPC is properly connected the yellow diode named ”Link” on the WM HPC will lit up. Software Upgrade installation manual Page 1 Ethernet connection Link diode lights up yellow Software Upgrade installation manual Page 2 From the operator panel on the heat pump • Switch operating mode to standby. • Navigate in the menu until you find System settings. • Under System Settings you can find Software Upgrade. Activate this function. WM HPC is now ready to be updated! But you need to change some settings in your PC. Software Upgrade installation manual Page 3 Network settings in your PC • Open the control panel and double click on ”Network Connections” • Changes in settings for your normal internet connection needs to be done. This is most commonly your ”Local Area Connection” • Right click on ”Local Area Connection” and select ”Properties” • Select TCP/IP and click on ”Properties” • Choose the following alternative: ”Use the following IP address” and use IP address 10.0.48.10 and the subnet mask 255.255.255.0 • Open the software update program you recently downloaded Software Upgrade installation manual Page 4 Control panel Double click on ”Network Connections” Software Upgrade installation manual Page 5 Network settings Right click on ”Local Area Connection” and choose ”Properties”. Software Upgrade installation manual Page 6 Local area connection •Select ”Internet Protocol (TCP/IP)” •Click on Properties Software Upgrade installation manual Page 7 Properties •Select the alternative ”Use the following IP address” •Use IP address: 10.0.48.10 •Use Subnet mask: 255.255.255.0 Your PC is now ready! Software Upgrade installation manual Page 8 Software Upgrade •User: config •Password: ef56 •Click on Start Upgrade •Installation process will start Software Upgrade installation manual Page 9 Done! When the installation process has completed the field to the right will turn green, and the WM HPC will restart once more. Wait until the upgrade is ready. The upgrade can take about 15 minutes. If something should go wrong the field will turn red. After the software upgrade, switch the heat pump back to operating mode to AUTO, and reset your network settings on your PC back to normal. Software Upgrade installation manual Page 10 Select the alternative ”Obtain an IP Address automatically” Software Upgrade installation manual Page 11
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project