INSTALLATION INSTRUCTIONS FOR P1241 For Wall Sconce Fixture

INSTALLATION INSTRUCTIONS FOR P1241 For Wall Sconce Fixture
INSTALLATION INSTRUCTIONS FOR P1241
For Wall Sconce Fixture
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R
AV E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D O D I S J O N C T E U
ASSEMBLING THE FIXTURE (Fig.1)
1 Shut off power at the fuse box or circuit breaker. If necessary,
2
3
Fig.1
remove the old fixture including the mounting hardware.
Carefully remove the fixture from the carton and check that all
parts are included as show in Figure 1.
Attach mounting plate (A) to the junction box with junction
box screws (B) (size:8-32*1/2”L) provided. The side marked
“GND” must face out.
CONNECTION THE WIRES (Fig. 2)
4 Connect the electrical wires as shown in Fig.2, making sure
that all wire nuts are secured. If your outlet has a ground wire
(green or bare copper), connect the fixture's ground Wire to
it. Otherwise, connect the fixture's ground wire directly to the
mounting plate using the green screw(C) provided. Tuck the
wire connections neatly into the junction box.
FINISHING THE INSTALLATION (Fig. 1)
5 Align fixture (D) onto mounting plate (A) and secure with
screws (E) and rubber washers (S).
To prevent moisture from entering the outlet box and causing
a short circuit, use clear caulking (i.e. Indoor/Outdoor silicone
sealant) to outline the outside of fixture backplate where it
meets the wall leaving a space at bottom to allow moisture a
means to escape (Fig.3).
Your installation is now complete. Return power to the junction box
and test the fixture.
6
Fig.2
CAUTION /ATTENTION: When handling the fixture, do not apply
pressure to the LEDs. Hold the fixture by the base or back plate
(D) only.
Replacing LED module (Fig. 4)
The LED module can be replaced by a qualified electrician without
cutting of wire and without damage to any decorative element to
which the fixture is attached. See installation steps for more details
(Fig. 4)
Fig.3
Warning: Turn off power at the circuit breaker before
replacing LED module.
a. To remove the fixture from the wall, loosen screws (E) and
remove rubber washers (S). Disconnect the wire connectors
and place the fixture on a clear flat surface.
b. Loosen screws (M) and remove rubber washers (R) to separate
front plate (F), spacer (W) and glass case (O).Loosen screws
(H) and (J) to remove the LED protective case (I).Remove the
waterproof silicon on the LED protective case (I). Loosen
screws (H) and remove cap (G) and glass panel (N).
c. Loosen screws (L), rubber washers (S), screws (P) and wire
fastener (Q). Carefully remove LED module (K).
d. Reverse steps a-c for installing the new LED module.
Note: The LED module should be provided by a specified supplier.
IMPORTANT: Fixture should be installed by a qualified electrician
to ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer
switches.
II 809
Fig.4
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising