datasheet for 6249 by Pomona Electronics

datasheet for 6249 by Pomona Electronics
Model 6249
Minigrabber® Test Clip to Multi-Stacking Banana Plug Test Lead
Newly designed Minigrabber® Test Clip Patch Cord offers a high 300 Volt and 5 amp rating.
Grabber width is a slim .36” (9,14 mm) for easier access to test terminals.
Grabber hook is gold plated Beryllium Copper to ensure signal integrity & attaches onto component leads up to
.060” (1,5 mm) O.D.
Grabber patch cord interfaces directly into the most popular multimeters configured with non-sheathed style
banana jacks, including Amprobe, Fluke, H-P, Tektronix and Wavetek.
Plug is molded directly to the cable in an integral one-piece design for a long lasting connection.
Multi-leaf banana spring material is nickel-plated Beryllium Copper for extended insertion life & low contact
Banana plug features top and side stacking for added test versatility.
High strand count silicone insulated wire offers excellent flexibility and high temperature resistance.
Body – Polypropylene
Hook – Beryllium Copper, Gold Plated, Compression Spring: Music Wire
Wire: 18 AWG, 65 x 36 t.c., Insulation – Silicone, .144” (3,66 mm) O.D., Color per part number.
Banana Plug:
Body – Brass, Nickel Plated, Spring – Beryllium Copper, Nickel Plated
Insulation – Polypropylene, Color per part number
IEC 1010 2-031
Operating Voltage:
Operating Current:
For CE Compliance and for personal safety, do not hold in hand when voltages exceed
30 Vrms/60 Vdc. Maximum voltage for hands free use: 300 Vrms.
Do not use on circuits where transient stresses can exceed the rated voltage.
5 Amperes Max.
Ordering Information
Model: 6249-XX-*
XX = Wire Length, Standard Lengths: 12” (30,48 cm), 24” (61 cm), 48” (122 cm)
* = Color: -0 Black, -2 Red
Ordering Example: 6249-48-2, Patch Cord is 48” (122 cm), Color is Red.
Additional lengths can be quoted upon request.
Sales: 800-490-2361
Technical Support: [email protected]
Fax: 425-446-5844
Europe: 31-(0) 40 2675 150 International: 425-446-5500
Where to Buy:
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm),
.xxx = ± .005” (,127 mm). All specifications are to the latest revisions.
Specifications are subject to change without notice. Registered trademarks are
the property of their respective companies.
Copyright © 2009
D1094498 Rev. 100
Page 1 of 1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF