Controlling a BLK-3-EWP
APPLICATION
DNA-510
Controlling a
BLK-3-EWP
Note
TELECOM SOLUTIONS
FOR THE
2 1 S T C E N T U RY
September 24, 2007
Automatically Turn On a One Million Candle
Power Strobe Anytime the DNA-510 is Activated
This application will allow you to automatically turn on a BLK-3-EWP strobe light anytime the DNA-510
is activated from any telephone on your phone system. You can simply access the phone system’s line
the DNA-510 is connected to or call the phone system extension or dedicated POTS line it is connected
to. The unit will automatically answer allowing you to enter a touch tone command to interrupt standard
paging or background music and announce a live emergency page, start a emergency pre-recorded message or start one of ten different alert tones. Note: Place mode switch in “Trunk” position when connecting to a phone system’s unused line input. Place mode switch in “Ring Trip” position when connecting to
a phone system’s unused station port or dedicated phone line.
Installation
VIKING
©
MODEL DNA-510
PAGING
VOLUME
MESSAGE
VOLUME
*UPS
Ring
Trip
MIN
MAX
1 2 3 4
*UPS
AUDIO
IN
AUDIO
OUT 1
5 6
7 8
Paging Amplifier
(not included)
EARTH
GROUND
Page Trigger Output
Selection (J5 Jumper)
TRIGGER
OUTPUT
TRIGGER
INPUT
PHONE LINE
INPUT
REC INPUT
120V AC
Trunk
MAX
DIGITAL MASS
NOTIFICATION ANNOUNCER
AUDIO
OUT 2
POWER 13.8V AC
VIKING
ELECTRONICS
HUDSON, WI 54016
MIN
120V AC
Mode Switch
(see Note above)
= Dry Contact
1 2 3 4
SPKR SPKR
Out
Out
+ - + -
9 10 11
Page
Trigger
Input
Paging
Input
Background
Music Input
ALERT
TONE
VOLUME
** Earth Ground
(optional)
Page
Audio Out
Dedicated
(POTS)
Phone Line
Phone System's
Unused Phone
Line Input
(Trunk Port) or
Unused Analog
Station Port
Optional Background Music
Source (not included)
120VAC
BLK-3-EWP Control Module
(included)
(+) Red with
Black stripe
3
(-) Black with
White stripe
* Note: 3-wire gel-filled butt connectors (3M Scotchlok UR2 not included), polarity sensitive.
9
11
8
10
7
6
5
620 Ohm
1/2 Watt
Resistor
4
Green with
Yellow stripe
3
info@vikingelectronics.com
Product Support Line...715.386.8666
Red with
Yellow stripe
2
1
** Note: To increase surge protection, fasten a wire from the
screw terminal to Earth Ground (grounding rod, water pipe, etc.)
2
*
ON
(+) Black
(-) Black with
White stripe
Rear View
of the
Strobe Light
(included)
*
S1
12V DC
Adapter
Included
To External Trigger (Example: Fire Alarm
Control Panel Trigger Relay Output)
1
or
Gel-Filled Butt
Connectors
(included)
Red (+)
Red (+)
Black (-)
Black (-)
Brown
Gray
To optional disable switch
Fax Back Line...715.386.4345
Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries
assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.
Fax Back Doc 880
Printed in the U.S.A.
Rev 3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising