Click_Here_for_Rotary_Trans_Replacement_Instructions

Click_Here_for_Rotary_Trans_Replacement_Instructions
Fresno, California 93727-1328
(559) 292-2171 • (800) 456-8168
Tools Required:
17mm socket wrench
3mm hex key
#2 Phillips Screwdriver
INSTRUCTION SHEET
Yamaha Rotary Trans Replacement
(Please read and understand instructions before beginning installation)
Parts Required:
Rotary Trans Assembly (Fig 1)
Sunrise Part Number 133106)
Fig. 1
Please refer to the Yamaha Plate Assembly
(Sunrise Part Number 133107) instructions for
removal of the Plate Assembly.
Remove the battery before performing any
maintenance on the Xtender .
Removal
1) Using a 17mm socket remove the nut securing the
axle to the Xtender unit.(Fig 2)
Fig. 2
2) Once the nut is removed the wheel assembly and
motor assembly can be separated by pulling them
apart. (Fig. 3)
3) Set the wheel assembly aside and lay the motor
assembly on a flat surface
Fig. 3
4) Use a 3mm Hex key to remove the three screws
that secure the plastic cover. (Fig. 4)
Fig. 4
SUNRISE MEDICAL
106998 REV. A
March
2008
PAGE 1
5) Unplug the Rotary Trans Connector from the circuit
board (Fig 5).
Fig. 5
6) Using a #2 Phillips screw driver remove the two
screws securing the Rotary Trans Assembly to the
motor assembly. Once the screws are removed, lift
the Rotary Trans Assembly off the motor assembly
(Fig 6).
7) Reverse the above procedure to install the new
Rotary Trans Assembly.
Fig. 6
SUNRISE MEDICAL
106998 REV. A
March
2008
PAGE 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising