Low Level Programming

Low Level Programming
TSPA-MP
Low-Level programming
It is possible to configure various system operating parameters from the keypad. This is
normally done at Gecko's factory or by the spa installer. It may be configured at anytime. To
program these system parameters, the Program switch must be held for 20 seconds. After this
time, the first parameter will be displayed (see below). For each parameter, use the Up/Down
keys to modify its value. To accept a new value, press the Program switch until all parameters
have been programmed. After the last parameter is programmed, the system resets itself and the
display returns to the normal time/temperature display. If no change is wanted for a particular
parameter, simply press the Program key to skip it and move on to the next one.
1. Pump #1 configuration:
Display:
P1 x
Value of x:
1 = single-speed
2 = two-speed
2. Pump #2 configuration:
Display:
P2 x
Value of x:
0 = not installed
1 = single-speed
2 = two-speed
3. Blower configuration:
Display:
bL x
Value of x:
0 = not installed
1 = single-speed
2 = two-speed
3 = three-speed
4. Light switch configuration:
Display:
LI x
Value of x:
0 = Not installed
1 = 12 VAC (single-intensity)
2 = 12 VAC (three-intensity)
3 = 120 VAC (Aux #1 relay)
4 = INTERNAL Fiber box control mode (ON Aux #1 and #2 relays)
5. Ozone configuration:
Display:
O3 x
Value of x:
0 = not installed
1 = on only during Filter cycle
2 = always on
6. Circulation pump configuration:
Display:
CP x
Value:
0 = not installed
1 = regulated (with spa temperature)
2 = always on
7. SER configuration:
Display:
SEr x
Value of x: 0 = Service message won’t be displayed
1 = Service message will be displayed every 8000 hours
8. HC/LC configuration:
Display:
Cu x
Value of x:
0 = Low Current (Heater off if more than one pump at High speed)
1 = High Current (no limitations)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising