SAFETY DATA SHEET

SAFETY    DATA    SHEET
SAFETY
DATA SHEET
Page : 1/9
Date Revised : May 20, 2015
Date Issued : Mar. 21, 2013
SDS No. F-02316 (US_EN)
SECTION 1: Identification of the substance/mixture and of the company/undertaking
1.1 Product identifier
: MX-C30NTC
1.2 Relevant identified uses of the substance or mixture and uses advised against
Use of the Substance/ Mixture
: Reprographic agents (Cyan Toner)
1.3 Details of the supplier of the safety data sheet
Company / USA
: SHARP Electronics Corporation
Address
: Sharp Plaza, Mahwah, New Jersey 07495-1163
Telephone number
: +1-800-237-4277
Company / Canada
: SHARP Electronics of Canada Ltd.
Address
: 335 Britannia Road East, Mississauga, Ontario L4Z 1W9
Telephone number
: +1-905-890-2100
1.4 Emergency telephone number
Telephone number
: +1-800-255-3924
(USA, Canada only)
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
Classification (Hazard Communication Standard)
Not Classified as hazardous
2.2 Label elements
Labelling (accordance with paragraph (f) of §1910.1200)
Hazard symbol
: None
Signal word
: None
Hazard statements
: None
Precautionary statements : None
2.3 Other hazards
Potential dust explosion hazard.
1/9
SAFETY
DATA SHEET
Page : 2/9
Date Revised : May 20, 2015
Date Issued : Mar. 21, 2013
SDS No. F-02316 (US_EN)
SECTION 3: Composition/information on ingredients
3.2 Mixtures
Components
Chemical Name
CAS-No.
Classification
IARC
Concentration
(REGULATION
(%)
(EC) No1272/2008)
Polyester resin
Confidential
Not Classified
None
70-80
Styrene-Acrylate copolymer
Confidential
Not Classified
None
5-10
Organic pigment
Confidential
Not Classified
None
1-5
Wax
Confidential
Not Classified
None
1-5
Amorphous silica
7631-86-9
Not Classified
None
1-5
SECTION 4: First aid measures
4.1 Description of first aid measures
General advice
:
In the case of accident or if you feel unwell, seek medical
advice immediately.
When symptoms persist or in all cases of doubt seek medical advice.
Protection of first-aiders
:
First Aid responders should pay attention to self-protection,
and use the recommended personal protective equipment
when the potential for exposure exists.
If inhaled
: If inhaled, remove to fresh air.
If not breathing, give artificial respiration.
If breathing is difficult, give oxygen.
Get medical attention.
In case of skin contact
:
Remove contaminated clothing and shoes.
Get medical attention if irritation develops and persists.
Wash clothing before reuse.
Thoroughly clean shoes before reuse.
In case of eye contact
: If in eyes, rinse well with water.
Get medical attention if irritation develops and persists.
If swallowed
: If swallowed, get medical attention.
Rinse mouth thoroughly with water.
4.2 Most important symptoms and effects, both acute and delayed
Risks
: Dust contact with the eyes can lead to mechanical irritation.
4.3 Indication of any immediate medical attention and special treatment needed
Treatment
: Treat symptomatically and supportively.
2/9
SAFETY
DATA SHEET
Page : 3/9
Date Revised : May 20, 2015
Date Issued : Mar. 21, 2013
SDS No. F-02316 (US_EN)
SECTION 5: Firefighting measures
5.1 Extinguishing media
Suitable extinguishing media
: Water spray
Alcohol-resistant foam
Dry chemical
Carbon dioxide (CO2)
Unsuitable extinguishing media
: High volume water jet
5.2 Special hazards arising from the substance or mixture
Specific hazards during firefighting
:
Do not use a solid water stream as it may scatter and spread
fire.
Exposure to combustion products may be a hazard to health.
Hazardous combustion products
: Carbon oxides
Nitrogen oxides (NOx)
5.3 Advice for firefighters
Special protective equipment for firefighters:
In the event of fire, wear self-contained breathing apparatus.
Use personal protective equipment.
Specific extinguishing methods
: Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.
Use water spray to cool unopened containers.
Remove undamaged containers from fire area if it is safe to
do so.
Evacuate area.
SECTION 6: Accidental release measures
6.1 Personal precautions, protective equipment and emergency procedures
Personal precautions
: Use personal protective equipment.
Follow safe handling advice and personal protective
equipment recommendations.
6.2 Environmental precautions
Environmental precautions
: Discharge into the environment must be avoided.
Prevent further leakage or spillage if safe to do so.
Retain and dispose of contaminated wash water.
Local authorities should be advised if significant spillages
cannot be contained.
6.3 Methods and material for containment and cleaning up
Methods for cleaning up
:
Sweep up or vacuum up spillage and collect in suitable
container for disposal.
3/9
SAFETY
DATA SHEET
Page : 4/9
Date Revised : May 20, 2015
Date Issued : Mar. 21, 2013
SDS No. F-02316 (US_EN)
Avoid dispersal of dust in the air (i.e., clearing dust surfaces
with compressed air).
Dust deposits should not be allowed to accumulate on
surfaces, as these may form an explosive mixture if they are
released into the atmosphere in sufficient concentration.
Local or national regulations may apply to releases and
disposal of this material, as well as those materials and items
employed in the cleanup of releases. You will need to
determine which regulations are applicable.
Sections 13 and 15 of this SDS provide information regarding
certain local or national requirements.
6.4 Reference to other sections
See sections: 7, 8, 11, 12 and 13.
SECTION 7: Handling and storage
7.1 Precautions for safe handling
Technical measures
: Static electricity may accumulate and ignite suspended dust
causing an explosion.
Provide adequate precautions, such as electrical grounding
and bonding, or inert atmospheres.
Advice on safe handling
: Do not breathe dust.
Do not swallow.
Avoid contact with eyes.
Handle in accordance with good industrial hygiene and safety
practice.
Keep container tightly closed.
Minimize dust generation and accumulation.
Keep away from heat and sources of ignition.
Take care to prevent spills, waste and minimize release to the
environment.
Hygiene measures
: When using do not eat, drink or smoke.
Wash contaminated clothing before re-use.
7.2 Conditions for safe storage, including any incompatibilities
Requirements for storage
areas and containers
: Keep tightly closed. Keep in a cool, well-ventilated place.
Store in accordance with the particular national regulations.
4/9
SAFETY
DATA SHEET
Page : 5/9
Date Revised : May 20, 2015
Date Issued : Mar. 21, 2013
SDS No. F-02316 (US_EN)
: Do not store with the following product types:
Advice on common storage
Strong oxidizing agents
Organic peroxides
Explosives
Gases
7.3 Specific end use(s)
Specific use(s)
:
No data available
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational Exposure Limits
Components
CAS-No.
Value type (Form of
Control parameters
Basis
TWA
80 mg/m3/ (%SiO2)
OSHA PEL
TWA
3 mg/m3
ACGIH TLV
exposure)
Amorphous silica
7631-86-9
8.2 Exposure controls
Engineering measures
Minimize workplace exposure concentrations.
Apply measures to prevent dust explosions.
Personal protective equipment
Eye protection
:
Not required under intended use
Hand protection
:
Not required under intended use
Skin and body protection
: Not required under intended use
Respiratory protection
:
Not required under intended use
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Appearance
:
powder
Colour
:
Blue
Odour
:
odourless
Odour Threshold
:
No data available
pH
:
No data available
Melting point/freezing point
:
100 - 130 °C
Initial boiling point and boiling range
:
No data available
Flash point
:
Not applicable
Evaporation rate
:
Not applicable
5/9
SAFETY
DATA SHEET
Flammability (solid, gas)
:
Page : 6/9
Date Revised : May 20, 2015
Date Issued : Mar. 21, 2013
SDS No. F-02316 (US_EN)
Not classified as a flammability hazard
Upper explosion limit
:
No data available
Lower explosion limit
:
No data available
Vapour pressure
:
Not applicable
Relative vapour density
:
Not applicable
Density
:
ca. 1.1 g/cm3
Bulk density
:
ca. 0.4 g/cm3
Solubility(ies) Water solubility
:
negligible
Partition coefficient: noctanol/water
:
Not applicable
Auto-ignition temperature
:
No data available
Decomposition temperature
:
No data available
:
Not applicable
Explosive properties
:
Not explosive
Oxidizing properties
: The substance or mixture is not classified as oxidizing.
Viscosity
Viscosity, dynamic
9.2 Other information
No data available
SECTION 10: Stability and reactivity
10.1 Reactivity
Not classified as a reactivity hazard.
10.2 Chemical stability
Stable under normal conditions.
10.3 Possibility of hazardous reactions
Hazardous reactions
:
Dust can form an explosive mixture in air.
Can react with strong oxidizing agents.
10.4 Conditions to avoid
Conditions to avoid
:
None known.
10.5 Incompatible materials
Materials to avoid
: Oxidizing agents
10.6 Hazardous decomposition products
No hazardous decomposition products are known.
6/9
SAFETY
DATA SHEET
Page : 7/9
Date Revised : May 20, 2015
Date Issued : Mar. 21, 2013
SDS No. F-02316 (US_EN)
SECTION 11: Toxicological information
11.1 Information on toxicological effects
Information on likely routes of exposure
:
Inhalation
Skin contact
Ingestion
Eye contact
Acute Toxicity
Ingestion(oral)
: LD50 > 2000mg/kg (Rats)
Inhalation
: LC50 > 5.0mg/L
Eye irritation
: Not an irritant (Rabbits)
Skin irritation
: Not an irritant (Rabbits)
Skin sensitizer
: No sensitization
Mutagenicity
: Negative (Ames Test)
Carcinogenicity
NTP
: Not listed
IARC monographs: Not listed
OHSA regulations : Not listed
Chronic Effect
: No data
SECTION 12: Ecological information
12.1 Ecotoxicity
On available data, toner is not harmful to aquatic organisms
12.2 Persistence and degradability
No data available
12.3 Bioaccumulative potential
No data available
12.4 Mobility in soil
No data available
12.5 Other adverse effects
No data available
SECTION 13: Disposal considerations
13.1 Waste treatment methods
Product
:
Dispose of in accordance with local regulations.
Contaminated packaging
:
Dispose of as unused product.
Empty containers should be taken to an approved waste
handling site for recycling or disposal.
7/9
SAFETY
DATA SHEET
Page : 8/9
Date Revised : May 20, 2015
Date Issued : Mar. 21, 2013
SDS No. F-02316 (US_EN)
SECTION 14: Transport information
14.1 UN number
:
None
14.2 UN proper shipping name
:
None
14.3 Transport hazard class(es)
:
None
14.4 Packing group
: None
14.5 Environmental hazards
:
None
14.6 Special precautions for user
:
Not applicable
14.7 Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code
Remarks
:
Not applicable for product as supplied.
SECTION 15: Regulatory information
15.1 Safety, health and environmental regulations/legislation specific for the substance or mixture
TSCA (Toxic Substances Control Act) :
All chemical substances in this product comply with all applicable rules or order under TSCA.
WHMIS Legislation (Canada) :
This product is not a controlled product.
SECTION 16: Other information
Full text of other abbreviations
ACGIH
:
American Conference of Governmental Industrial Hygienists
IARC
:
International Agency for Research on Cancer
OSHA
:
Occupational Safety and Health Administration
PEL
:
Permissible Exposure Limit
TLV
: Threshold Limit Value
TWA
: Time Weighted Average
Further information
Sources of key data used to compile the Safety Data Sheet:
Internal technical data, data from raw material SDSs, OECD eChem Portal search results and European
Chemicals Agency,http://echa.europa.eu/
The information provided in this Safety Data Sheet is correct to the best of our knowledge, information
and belief at the date of its publication. The information is designed only as a guidance for safe handling,
use, processing, storage, transportation, disposal and release and shall not be considered a warranty or
quality specification of any type. The information provided relates only to the specific material identified at
the top of this SDS and may not be valid when the SDS material is used in combination with any other
8/9
SAFETY
DATA SHEET
Page : 9/9
Date Revised : May 20, 2015
Date Issued : Mar. 21, 2013
SDS No. F-02316 (US_EN)
materials or in any process, unless specified in the text. Material users should review the information and
recommendations in the specific context of their intended manner of handling, use, processing and storage,
including an assessment of the appropriateness of the SDS material in the user’s end product, if applicable.
Date Issued
: Mar. 21, 2013
Date Revised : May 20, 2015
9/9
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising