Rhodeus Installation Guide
17 & 18 RS‐232 Serial Port (COM1/COM2) Type: onboard 2.0mm 2*5‐pin box header Pin 1 3 5 7 9 Description DCD TXD GND RTS RI Pin 2 4 6 8 10 Description RXD DTR DSR CTS NC RHODEUS – LC
Quick Installation Guide Solder Side
Version 1.0 200‐pin DDR SDRAM DIMM Socket (DIMM1) Compact Flash Connector (CFD1) Note: CFD1 does not support hot swap. Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 Description GND DATA3 DATA4 DATA5 DATA6 DATA7 CS#1 GND GND GND GND GND +5V GND GND GND GND ADDR2 ADDR1 ADDR0 DATA0 DATA1 DATA2 N.C. GND Pin 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 Description GND DATA11 DATA12 DATA13 DATA14 DATA15 CS#3 GND IO READ IO WRITE +5V IRQ 14 +5V CSEL N.C. IDE RESET DRDY DREQ DACK DASP DIAG DATA8 DATA9 DATA10 GND www.diamondsystems.com Rhodeus – LC
PC/104 Form Factor Embedded AMD Geode LX SBC with CRT/LCD, Ethernet, PC/104 and Compact Flash Socket Technical Support
Please do not hesitate to call or e‐mail our customer service department if you have questions about this product or if you would like to learn more about Diamond Systems. Part Number: 7460571 (650) 810‐2500 techinfo@diamondsystems.com www.diamondsystems.com Copyright © 2008 All Rights Reserved. 01 PS/2 Keyboard and Mouse (KBM1) Type: onboard 6‐pin water connector Pin Description 04 Power Connector (PWR1) Type: onboard 4‐pin power connector Specification
1 2 3 4 5 6 KB_DATA GND MS_DATA KB_CLK VCC MS_CLK Pin 1 2 3 4 Processor AMD Geode™ LX series CPU Chipset AMD CS5536 System Memory LCD One 1 x 200‐pin DDR SO‐DIMM up to 1GB AMD Geode LX800 integrated VGA controller with 2D engine Supports 18/24‐bit TTL up to 1280 x 1024 PCI to ISA BRIDGE ITE8888G (Master ISA and PNP feature not supported) Ethernet Realtek 8100CL 10/100 Base‐T I/O Chips Winbond 83627HG 07 LAN LED Indicator (LLED1)
Type: onboard 2.54mm 1*4‐pin header BIOS Phoenix‐Award BIOS, supports 4MB Flash ROM 05 PC/104 ISA Interface (PC 104_1)
06 COM2 RS‐232/422/485 Select (JRS1) Type: onboard 2*3‐pin header Select RS‐232 (default) RS‐422 RS‐485 Pin 2 4 6 8 10 Description TX1‐ N.C RX‐ N.C Key 03 Enhanced IDE Connector (IDE1) Type: onboard 2.0mm 2*22‐pin header Pin 1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 41 43 Description IDE RESET DATA7 DATA6 DATA5 DATA4 DATA3 DATA2 DATA1 DATA0 GND REQ IO WRITE IO READ IO READY DACK IRQ14 ADDR1 ADDR0 CS#2 IDEACTP +5V GND Pin 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 42 44 Description GND DATA8 DATA9 DATA10 DATA11 DATA12 DATA13 DATA14 DATA15 KEY GND GND GND IDESEL GND N.C DIAG ADDR2 CS#3 GND +5V N.C PC/104 form factor 02 Fast Ethernet Connector (LAN1) Type: onboard 2.0mm 2*5‐pin header Description TX+ RX+ N.C N.C GND Form Factor Pin 1 3 5 7 9 Description +5V GND GND +12V 1‐2 ON OFF OFF 3‐4 OFF ON OFF VGA/ LCD Controller 5‐6 OFF OFF ON Parallel Port ATA‐33 x 1 channel (supports one ATAPI device) Compact Flash Disk x 1 use Primary IDE Master resource (supports up to 4GB) Two COM ports:
COM 1: RS‐232 COM 2: RS‐232/422/485 Parallel port supports SPP/EPP/ECP mode K/B and Mouse Supports standard PS/2 K/B and Mouse Floppy 1 x Floppy Drive Connector Universal Serial Bus. 2 x USB 2.0 port Watchdog Timer 1~255 Level (Sec. or Min.) Hardware Monitor Integrated in W83627HG RTC Power Input Connector Operation Temp. AMD Geode CS 5536 built‐in RTC with lithium battery Dimension (Lx W) 96 x 90mm (3.8” x 3.5”) Pin 1 2 3 4 Description LAN1 ACTIVE‐ LAN1 ACTIVE+ LAN1 LINK‐ LAN1 LINK+ IDE Interface Two Serial Port 08 Front Panel (Switches & Indicators) (JFRT1) Type: onboard 2.54mm 1*8‐pin header Pin 1 2 3 4 5 6 7 8 Description RESET+ RESET‐ PWRLED+ PWRLED‐ HDLED+ HDLED‐ ESPK+ ESPK‐ 09 Infrared (IR) Connector (IR1)
Type: onboard 2.54mm 5‐pin header Pin 1 2 3 4 5 Description +5V N.C IRRX GND IRTX 1 x 4‐pin 5V, 12V power connector ‐20°C to +70°C 10 CRT Display Connector (VGA1) Type: onboard 2.0mm 2*8‐pin header Packing List
Before you begin installing your single board computer, please make sure that the following materials have been shipped: ™ 1 Rhodeus‐LC Embedded SBC ™ 1 Quick Installation Guide ™ 1 Diamond Systems CD Pin 1 3 5 7 9 11 13 15 Description RED BLUE GND GND N.C N.C (Key) HSYNC VDCLK Pin 2 4 6 8 10 12 14 16 Description GREEN N.C GND GND GND VDDAT VSYNC N.C Pin 1 3 5 7 9 11 13 15 17 19 11 USB Connector (USB1) Type: onboard 2.0mm 2*5‐pin header Optional
™ 1 Cable Kit containing the following: • 1 USB V2.0 Cable • 2 COM Flat Cables • 1 FDD Flat Cable • 1 IDE Cable • 1 Print Cable • 1 LAN Cable • 1 VGA Cable • 1 K/B‐M/S Cable Pin 1 3 5 7 9 USB_VCC USBD‐ USBD+ USB_GND USB_GND 2 4 6 8 10 Descriptio
n USB_VCC USBD‐ USBD+ USB_GND N.C (Key) PC/104 Form Factor Embedded AMD Geode LX800 SBC with CRT/LCD, Ethernet, PC/104 and Compact Flash Socket up to 4GB C‐RDS‐KIT Description 12 Floppy Disk Drive Connector (FDD1) Type: onboard 2.0mm 2*10‐pin header Ordering Information
RDS800 – LC Cable Kit Pin 14 Parallel Port Connector (LPT1) Type: onboard 2.0mm 2*10‐pin header Pin Description Pin 1 3 5 7 9 11 13 15 17 19 GND GND GND ‐WDATA ‐WGATE ‐TRACK0 ‐WP ‐RDATA ‐HEAD ‐DSKCHG 2 4 6 8 10 12 14 16 18 20 Descriptio
n DRVDEN0 KEY DRVDEN1 ‐INDEX ‐MOA ‐DSB ‐DSA ‐MOB ‐DIR ‐STEP 13 CMOS Jumper Settings (JBAT1) Type: onboard 3‐pin header CMOS Keep CMOS (default) Clear CMOS JBAT1 1‐2 ON 2‐3 ON Description STROBE PTD0 PTD1 PTD2 PTD3 PTD4 PTD5 PTD6 PTD7 ACK Pin 2 4 6 8 10 12 14 16 18 20 Description AFD ERROR INIT SLIN GND GND GND (Key) BUSY PE SELECT 15 RS422/485 Output Connector (CON1) Type: onboard 2.0mm 4‐pin water conn. Pin 1 2 3 4 RS‐422 TX+ TX‐ RX+ RX‐ RS‐485 Data+ Data‐ N.C N.C RS‐422/RS‐485 Selected by JRS1, share COM2 resource 16 TTL LCD Panel Connector (LCD1) Type: onboard DF‐13‐40DP‐1.25V Pin 1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 Description VDD5 GND VDD3 N.C LPD0 LPD2 LPD4 LPD 6 LPD 8 LPD 10 LPD 12 LPD 14 LPD 16 LPD 18 LPD 20 LPD22 GND DOTCLK DE BLON Pin 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 Description VDD5 GND VDD3 GND LPD1 LPD 3 LPD 5 LPD 7 LPD 9 LPD 11 LPD 13 LPD 15 LPD 17 LPD 19 LPD 21 LPD 23 GND FP_VS FP_HS ENVDD Jumper/Connector Quick Reference
Jumpers and Connectors
Jumpers Label JRS1 JBAT1 Function COM2 RS‐232/422/485 Select CMOS Jumper Settings Connectors 5 1 10 16 17, 18 15 9 14 2 7 11 4 8 12 3 DIMM1 PC/104 KBM1 VGA1 LCD1 COM1 ~ COM2 CON1 IR1 LPT1 LAN1 LLED1 USB1 PWR1 JFRT1 FDD1 IDE1 CFD1 200‐pin DDR SDRAM DIMM Socket (on bottom) PC/104 for ISA Interface PS/2 Keyboard and Mouse CRT Display TTL LCD Panel Connector Serial Ports RS‐422/485 Output Infrared (IR) Connector Parallel Port LAN Ethernet Connector LAN LED Connector USB 1/2 Connector Power Connector Small 4P Front Panel (Switches and Indicators) Floppy Disk Drive Connector Primary IDE Connector Compact Flash Socket (on bottom) 
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising