ig controlspace edr linelevelinputcard

ig controlspace edr linelevelinputcard
ControlSpace® EDR line level input card
CAUTION: Installation should only be performed by trained service personnel.
CAUTION: Make no modification to the system or accessories. Unauthorized alterations may compromise safety, regulatory compliance and system performance.
CAUTION: ESD sensitive device. Handle with care.
1. Turn off and unplug the ESP.
2. Detach the top cover by removing the 8 screws.
3. Remove a bracket from an empty slot from slots 5-8 by removing the 2 screws (save these screws). The EDR input card will replace this bracket.
4. Position the card in the chassis. Be sure to align the card’s LEDs with the holes in the front of the chassis, and make sure the connector on the side
of the card is aligned with the connector on the motherboard. Use the black guide on the bottom of the case to direct the card using the grooves.
See Figure 1.
5. When the connector on the card is aligned above the connector on the motherboard, press gently to mate the connectors. See Figure 2.
6. Screw the card into place.
7. Reattach the top cover and fasten the 8 screws.
8. Plug in the power supply and turn on the ESP.
Figure 1
Figure 2
9. Use the ControlSpace® Designer™ software to verify the card was inserted
Figure 3
10. a) Press scan and confirm that the software detects the card.
b) If the card was installed correctly, right-clicking the ESP and displaying
its properties will show 4Ch EDR Input in the correct slot in the ESP.
See Figure 3.
11. If an error message appears, or the software does not properly detect the
EDR Input card, repeat the installation instructions. Be sure that the card is
completely pushed into the connector, and that the card is properly aligned in
the chassis.
©2010 Bose Corporation, The Mountain Framingham,
MA 01701-9168 USA
AM299786 Rev.01
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF