Product Data Sheet g di i

Product Data Sheet g di i
Product Data Sheet
digidim
312
DIGIDIM Multi-Sensor
Introduction
The DIGIDIM Multi-sensor is a compact unit containing the necessary sensors
to provide energy saving functions when used in a DALI system. It contains
a light sensor, a passive infra-red detector (PIR) and an infra-red receiver
that allows the multi-sensor to be operated by the hand held DIGIDIM remote
controller. The PIR enables the system to detect when a room is occupied and
the light sensor measures the level of ambient light available. The infra-red
receiver and DIGIDIM remote controller allow the room occupants to set the
required light levels and to carry out basic system programming. The multisensor is designed to push fit into a ceiling or luminaire housing.
DIGIDIM Multi-Sensor
Key Features
•
Presence detection has a default time out of 20 minutes and a test
mode of 20 seconds.
•
Programmable constant light control for maximum energy efficiency.
•
Complete control using the hand held remote.
•
Local switch can be fitted to provide ON/OFF and a manual dimming
function if required.
•
The Multi-sensor is fitted with five DIL switches which control the
units programmable functions.
•
Manual switch settings can be overridden by DIGIDIM Toolbox
software to eliminate the need for access to multi-sensor after
installation.
Constant Light Coverage without restrictor
Constant Light Coverage with restrictor
Additional Functions
•
Most Multi-sensor functions programmable using the hand held
remote, but full system access is available by using the DIGIDIM
Toolbox software.
•
If multiple linked PIR sensors are connected in one system they will
communicate with each other and only switch off the loads when
all are non-detecting.
•
The advanced presence detection system utilises three
programmable steps during the automatic ON/OFF sequence.
These functions permit the user to determine how the loads react
to the automatic presence detection commands from the multisensor.
Scene 14
Intermediate scene/light level prior to OFF
Scene 15
Fully programmable OFF scene
Scene 16
Last level set by user
No presence
detected
(Lights off)
Scene 16
Current Level
Scene 14
Intermediate level
Scene 15
Off scene
20 mins (Default)
Doc.7860047GB Issue 1
20 secs
(Default)
Presence
detected
(Lights on)
Presence Detection Coverage
Product Data Sheet
DIGIDIM Multi-Sensor
digidim
312
Dimensions
Technical Data
Connection
DALI:
Standard DIGIDIM removable
connectors with paired terminals
2 wire 0.5 mm2 - 1.5 mm2 solid or
stranded.
Local Control:
2 wire 0.5 mm2 - 1.5 mm2 solid or
stranded.
Maximum length 50 m
Installation
NOTE: All cables should be mains rated.
Power
DALI Supply:
DALI Consumption:
None (Power supply must be
provided elsewhere in the system)
15 mA
Operating Conditions
Ambient Temperature:
Relative Humidity:
Storage Temperature:
0 …50°C
90% maximum, non-condensing
-10°C … 70°C
Mechanical Data
Please see drawings for full details.
Finish:
Satin white plastic
Weight:
48g without shroud
54g with shroud
Connections
Conformity & Standards
EMC
Emission:
Immunity:
Safety
Safety:
IP Rating:
Isolation:
EN 61 547
EN 55 015
EN 60 950
30
4 kV
Local Control
Data subject to change without notice
Hawley Mill, Hawley Road, Dartford, Kent, DA2 7SY United Kingdom Tel: +44 (0)1322 222211 Fax: +44 (0)1322 282216
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising