INSTRUCTIONS FOR INSTALLING KBSC SPEED CONTROL !

INSTRUCTIONS FOR INSTALLING KBSC SPEED CONTROL !
INSTRUCTIONS FOR INSTALLING KBSC SPEED CONTROL
!
SAFETY WARNING! Please read carefully before proceeding
Unit should be installed by a qualified electrician in accordance with the national electrical code and other local codes which may apply. This
control must be grounded when installed. Failure to follow these instructions may result in electrical shock or a fire hazard. To reduce the risk of
fire or electric shock, this control is to be used only with fans marked as suitable for use with solid state state speed controls. This control is suitable for mounting a metal or polymetric field enclosure. These controls must not be used at ratings exceeding those clearly marked on the device.
We are not responsible for any expense, inconvenience or consequent damage caused by items of our manufacture or sale.
1. APPLICATION
a) Motor Type – Shaded Pole, P.S.C., and Universal.
b) Required Load – Fans, Blowers and speed dependent
loads.
CONNECTION DIAGRAM FOR 2-WIRE CONTROLS (SWITCH MODELS)
SWITCH
2. WIRING
Warning! – Power must be turned off before wiring.
Connect control in series with motor and line voltage –
never connect control across line.
TRIAC
AC
LINE
CONTROLLED
LOAD
3. MOUNTING
a) Drill 3/8” hole using mounting template below.
b) Lock washer may be used to prevent unit from rotating.
c) Dial Plate may be secured with bushing lock nut or selfadhesive backing
4. MINIMUM SPEED ADJUSTMENT
Important – If this option is not supplied, disregard step 4
and continue to step 5.
This control was designed to operate on motors used in
diversified applications. A minimum speed adjustment is
provided to allow independent control of the minimum
speed setting.
a) Motor must be in actual operating conditions to achieve
proper speed adjustment. (Motor will not slow down
unless proper load is applied.)
b) Turn main speed control knob clockwise to lowest speed
position.
c) Locate and adjust minimum speed setting on the side of
the control with an insulated screw driver (rotate clockwise to decrease minimum speed; counter-clockwise to
increase minimum speed.
d) Motor will now operate from this preset minimum speed
to full speed.
CONNECTION DIAGRAM FOR NO SWITCH MODEL (NS) 2-WIRE CONTROLS
MOTOR CONTROL
AC
LINE
CONTROLLED
LOAD
PANEL DRILLING TEMPLATE
3/8d
5/8
5. FINAL MOUNTING – SWITCH MODELS
a) Install front dial plate (remove protective plastic on face
of dial plate).
b) Turn main control until switch snaps off.
c) Push on knob so that pointer is on the “off” position.
MOUNTING NOTE – For No Switch Models (NS) install
front dial plate and push on knob.
KB ELECTRONICS, INC.
12095 NW 39th Street, Coral Springs, FL 33065-2516 • (954) 346-4900 • Fax (954) 346-3377
Outside Florida Call Toll Free (800) 221-6570 • E-mail – info@kbelectronics.com
www.kbelectronics.com
15/16
17/16 sq
(A40005) – Rev. B – 6/2001
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising