INST95-8904B_web
INSTALLATION INSTRUCTIONS FOR PART 95-8904B
APPLICATIONS
Subaru Legacy 2009-up
Subaru Outback 2009-up
(non nav models)
95-8904B
KIT FEATURES
• DDIN radio provision
• ISO stacked provision
• Painted scratch resistant matte black
Note: Minor sub-dash modifications required.
Part # 95-8903B does not require these modifications.
KIT COMPONENTS
• A) DDIN Trim Plate • B) DDIN Brackets
A
B
WIRING & ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness: • 70-8901 Subaru harness 1990-up
• 70-7552 Nissan harness 2007-up
Antenna Adapter: • 40-SB10 Subaru antenna adapter 2005-up
TOOLS REQUIRED
Panel Removal Tool • Phillips Screwdriver • Small Flat Blade Screwdriver • Utility Knife • Cutting Tool
METRA. THE WORLD’S BEST KITS.™
metraonline.com
1-800-221-0932
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
95-8904B
Table of Contents
Dash Disassembly
– Subaru Legacy 2009-up
– Subaru Outback 2009-up
3
3
Kit Assembly
– DDIN/stacked ISO head unit provision
4
Caution
Metra recommends disconnecting the negative battery terminal before beginning any
installation. All accessories, switches, and especially air bag indicator lights must be
plugged in before reconnecting the battery or cycling the ignition.
*NOTE: Refer also to the instructions included with the aftermarket radio.
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
95-8904B
Dash Disassembly
1. Unclip and remove the radio trim panel
including the a/c vents. (Figure A)
2. Remove (4) Phillips screws securing the
factory radio.
Continue to kit assembly
(Figure A)
3
Kit Assembly 95-8904B
DDIN/stacked ISO head unit provision
1. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
2. Attach the Double DIN brackets to the
Double DIN trim plate. (Figure A)
3. Slide the Double DIN head unit or
stacked ISO head units into the bracket/
radio housing assembly and secure the
Double DIN head unit or stacked ISO
head units to the assembly using the
screws supplied with the radio.
(Figure B)
(Figure A)
4. Using an air saw, hacksaw, or similar
cutting tool, cut to the inside of the
radio’s lower mounting holes, through
the plastic and metal bracket.
(Cut on the inside of each hole as
close to the hole as you can get. If
cut properly you may re-use two
bottom factory screws, if not use
self tapping screws on the bottom.)
(Figure C)
(Figure B)
4. Reassemble dash in reverse order
of disassembly.
(Figure C)
6
Notes
Notes
Notes
REV. 6/02/11
INSTALLATION INSTRUCTIONS FOR PART 95-8904B
METRA. THE WORLD’S BEST KITS.™
metraonline.com
1-800-221-0932
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising