Manual 8481122
AFTER CARE INSTRUCTIONS
Your fitting has been manufactured to a high quality finish therefore
should be treated with care to preserve its visible appearance. All
surface finishes will wear if not cleaned correctly, the recommended
and safest way to clean your fitting is to wipe with a soft damp cloth.
Stains can be removed using washing up liquid. All domestic
cleaning products, including non-scratch cleaners, can damage the
surface and appearance of your fitting.
GUARANTEE
All products are manufactured to the highest standards and a 5 year
guarantee covers any defect in manufacture.
NOTE: The 5-year guarantee on the valve is invalidated if
damaged by any waterborne debris.
In the interest of continuous product development we reserve the
right to alter specifications as necessary.
Torre
Deck Sink Mixer
PRODUCT CODE: TO DSM C
TELEPHONE HELPLINE : 0844 701 6273
Bristan Group Ltd
Birch Coppice Business Park
Dordon
Tamworth
Staffordshire
B78 1SG
UK
A Masco Company
Fitting Instructions
& Contents List
Website: www.bristan.com
Telephone: 0844 701 6274
Facsimile: 0844 701 6275
Email: enquire@bristan.com
(FI TO DSM)
Please keep these instructions for future reference
and request of replacement parts.
(D2)
(H)
WATER PRESSURE
CONTENTS
This mixer is suitable for use at all supply pressures. However for
optimum use both the hot and cold supplies should be reasonably
balanced. If the fitting is installed at low pressure (tank fed), then the
minimum distance from the outlet of the nozzle to the underside of
the cold tank should be 2 metre to ensure adequate performance.
1.
2.
3.
4.
N.B. This mixer is supplied with a single check valve fitted to the hot
inlet. To comply with Water Regulations a further check valve should
be fitted to the cold supply. For further details contact your Local
Water Authority.
INSTALLATION
1.
2.
3.
4.
5.
Spout
Mixer Body
Plinth
Backnut
(x1)
(x1)
(x2)
(x2)
Fig. 1
1
a
b
Fig. 1a
Identify all components and check for completeness, particularly
before arranging fitting.
Fit the spout (1) into the body (2), ensuring the spout is able to
rotate freely (See Fig. 1a).
Fit the mixer to the sink, using the plinths (3) above and
backnuts (4) below, and connect the hot and cold water
supplies.
Fully open both valves, letting them run for a few minutes to
check all joints and connections for leaks.
See over the page for aftercare instructions.
c
d
e
Rubber Seal
MAINTENANCE
Seating
If the fitting begins to drip:
1.
2.
3.
4.
5.
Turn off the water supply.
Unscrew cap (a), remove indice (b), loosen handle screw (c)
and lift off handle (d).
Unscrew valve (e) and carefully clean seating, rubber washer
and ceramic disc.
Replace valve and handle then turn on the water supply.
Contact our helpline, quoting the product code, if problem
persists.
3
2
4
Please note:
In the unlikely event you find a part missing please contact our
Customer Service Help line on 0844 701 6273 for immediate
despatch of part.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising