045210AC-6

045210AC-6
MODEL №: 045210AC-6
AMERICAN SPECIALTIES, INC.
441 Saw Mill River Road, NY 10701
(914) 476.9000 • (914) 476.0688
www.americanspecialties.com
ISSUED:
10/09
REVISED:
09/10
SEMI-RECESSED AUTOMATIC ROLL PAPER TOWEL DISPENSER
1" [25]
REAR
ONLY
1-3 8" [35]
7
8" DIA [Ø22]
3 KNOCK OUTS
FOR POWER
1-TOP
1-SIDE
1-BACK
SERVICE OUT LET FOR
DISPENSER POWER ADAPTER
7
8" DIA [Ø22] KNOCK OUT
FOR POWER REAR WALL
1
17-1 4"
[438]
TUMBLER
LOCK
4"
[6.4]
1"
[25]
TYP
NOTE: ALL DIM'S
ARE INCH [MM]
10" [254]
6"
[152]
2-1 4"
[57]
1-3 16"
[30]
15-3 4" [400]
2-3 16" [56]
SIDE ONLY
1-14" [32]
REAR ONLY
1-5 8" [41]
REAR & TOP
13"
[330]
SIDE POWER
CABLE ENTRY
7-12"
[191]
TUMBLER
LOCK
NO TOUCH - PLACE HAND BELOW
13"
[330]
7
32" DIA
[Ø5.6]
MOUNTING
HOLES
26-12"
TYP
2 @ SIDE [673]
48" AFF [1219]
ADA MAX
40" AFF [1016]
CBC MAX
28"
[711]
REAR POWER
CABLE ENTRY
ROUGH WALL OPENING
MINIMUM DEPTH
4"
[102]
LED
INDICATOR
SEMI
RECESSED
MOUNTING
COLLAR
-6
1" [25]
26"
[660]
RECOMMENDED MOUNTING HEIGHT AFF
62-14" TO 69-14" [1581 TO 1759]
2-7 16"
[62]
SIDE
PIANO
HINGE
BARRIER FREE MOUNTING HEIGHT MAX AFF
ADA REACH 61-1 4" [1556] • CBC ALL REACH 53-14" [1353]
2-7 8"
[73]
SPECIFICATION
Semi-Recessed Automatic Roll Paper Towel Dispenser shall hold and dispense one 8" wide x 8" diameter (203 x Ø203) standard towel roll up
to 800 ft. (244m) long and one 8" wide (203) stub roll up to 4" diameter (Ø102). Automatic Touchless Roll Towel Dispenser shall be powered by C-UL-US and CE approved internal low-voltage adapter (supplied) using 110-240VAC, 50/60 Hz and providing output of 5VDC @
1A and shall operate automatically to activate towel dispensing when hands are placed in sensor zone. Unit shall feed out a length of towel
during each activation selected by owner by setting length, delay and paper saver switches. Unit shall have an internal towel cut-off bar. Cabinet and frame shall be fabricated of 22 gauge type 304 stainless steel alloy 18-8, and towel dispenser door shall be 18 gauge same grade. All
exposed surfaces shall have satin finish protected by PVC plastic film easily removed after installation. Door shall be attached to cabinet at
side with a full-length 3/16" diameter (Ø 4.8) stainless steel multi-staked piano hinge and shall have a full return and hemmed bottom edge for
user safety. Door shall be held closed with a tumbler lock keyed alike to other ASI washroom equipment. Face trim shall be 1" (25.4) wide
formed from one piece with no miters, welding or open seams and have four (4) 1/4" (6.4) square returns to collar. Structural assembly of all
components shall be of welded construction. Cabinet shall have no exposed fastening devices or spot-welded seams.
Semi-Recessed Automatic Roll Paper Towel Dispenser shall be Model № 045210AC-6 as manufactured by American Specialties,
Inc., 441 Saw Mill River Road, Yonkers, New York 10701-4913
INSTALLATION
Unit is mounted in wall recess using № 10 self-tapping screws (by others) through concealed mounting holes provided. Note that top of RWO
is 3/4" (19) below top of unit. For compliance with ADA Accessibility Guidelines, install unit so that bottom edge of towel dispenser door is
48" (1219) maximum above finished floor (MAX AFF). Power is supplied by code approved cable or conduit (by others) to RWO at any one
of three [3] available locations indicated on diagram and terminated in utility simplex outlet box (provided) inside cabinet. Power required is
110-240VAC at 50/60 Hz protected by a 15A circuit breaker (by others) for low voltage adapter that draws ¼ Amp. Power adapter for dispenser unit is supplied cabled and plugged into dispenser and is plugged into simplex outlet (by others). Sensor ground wire must be connected
inside cabinet.
Rough Wall Opening (RWO) required is 15-3/4" W x 26-1/2" H x 4" D (400 x 673 x 102)
OPERATION
Towels are dispensed one length at a time automatically when hands are placed in sensor zone until supply is depleted. Length of towel
dispensed is predetermined by owner by making selections on three (3) three-position switches for length, delay, economy. Unit may be
reloaded with a full roll to automatically start when finished with an existing partial roll. LED indicates sensing and operation. Locking
door prevents unauthorized access and roll removal.
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising