SHOWER TRAY INSTRUCTION

SHOWER TRAY INSTRUCTION
to
ls
o
SHOWER TRAY
INSTRUCTION
Failure to follow instructions correctly may lead to the
acrylic cap separating from the body of the tray.
1
re
qu
ire
d
Any Queries? Call : 08000 23 23 23
2
Remove protective plastic film from the areas near the waste and
those sides of the tray which will be against a wall.
Ensure that the location of the shower tray is firm, level, and
clean.
3
4
Install the shower tray on a bed of weak cement mix
(sand/cement ratio 5:1). Tile adhesive can be used as an
alternate to sand or cement. Please note if using water based
adhesives, to enhance the bonding it is suggested that a
suitable primer is applied to the base of the shower tray before
installation.
Fit the shower tray waste.
Ensure the two side edges are flat to the wall.
Place the shower tray onto the cement bed and apply gentle
pressure with the palm of the hand to bed the tray into
position.
6
5
Tile and seal joints with an anti fungal silicone sealant and allow to set.
Care and maintenance
Level the tray and allow to set.
When shower tray is set remove the remainder of the
protective plastic film and connect the waste pipe and check
for leakage.
Please seal joints between tray and wall with an
anti fungal silicone sealant and allow to set.
It is advised that the shower tray is cleaned regularly, to remove any
insoluble products. Hot soapy water should be used and then the tray
should be wiped. Cleaners of gritty or abrasive nature should never be
used.
The acrylic surface of this shower tray has good resistance properties
to acids but should not come into contact with alkalis or organic
solvents, such as caustic soda, dry cleaning agents and paint strippers.
1-1
B
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement