BFRC-KIT BFRC-KIT-OP Optional Remote Control Installation Guide

BFRC-KIT BFRC-KIT-OP Optional Remote Control Installation Guide
Installation Guide
Optional Remote
Control
Model Numbers:
BFRC-KIT
BFRC-KIT-OP
IMPORTANT SAFETY INFORMATION: Always read this manual first
before attempting to install. For your safety, always comply with all
warnings and safety instructions contained in this manual to prevent
personal injury or property damage.
To view the full line of Dimplex products, please visit
www.dimplex.com
7206620100R07
Table of Contents
Welcome & Congratulations . . . . . . . . . . . . . . 3
Important Instructions . . . . . . . . . . . . . . 4
Remote Kit Installation . . . . . . . . . . . . . . . . . . . 5
Installation Set Up . . . . . . . . . . . . . . . . . . . . . 5
Install Remote Control Receiver. . . . . . . . . . 6
Remote Control Initialization/Reprogramming . . . . . 7
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Remote Control Usage . . . . . . . . . . . . . . . . . 8
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Battery Replacement . . . . . . . . . . . . . . . . . . . 9
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
!
Always use a qualified technician
or service agency to repair
this fireplace.
NOTE: Procedures and
techniques that are
considered important
enough to emphasize.
CAUTION: Procedures and
techniques which, if not
carefully followed, will result
in damage to the equipment.
Warning: Procedures
and techniques which, if not
carefully followed, will expose
the user to the risk of fire,
serious injury, or death.
2
www.dimplex.com
Welcome & Congratulations
Thank you and congratulations for choosing to purchase an electric
fireplace from Dimplex, the world leader in electric fireplaces.
Please carefully read and save these instructions.
CAUTION: Read all instructions and warnings carefully before
starting installation. Failure to follow these instructions may result in a
possible electric shock, fire hazard and will void the warranty.
NO NEED TO RETURN TO THE STORE
Questions with operation or assembly? Require Parts Information?
Product Under Manufacturer’s Warranty?
Contact us at:
OR
 www.dimplex.com/customer_support
For Troubleshooting and Technical Support
 Toll-Free 1-888-DIMPLEX (1-888-346-7539)
Monday to Friday 8:00 a.m. to 4:30 p.m. EST
3
Important Instructions
① Read all instructions before
using this appliance.
② Any repairs to this appliance
should be carried out by a
qualified service person.
③ Under no circumstances
④ Do not use outdoors.
⑤ Use this appliance only as
described in this manual. Any
other use not recommended by
the manufacturer may cause fire,
electric shock or injury to persons.
should this appliance be modified.
Parts having to be removed for
servicing must be replaced prior
to operating this fireplace again.
SAVE THESE Instructions
4
www.dimplex.com
Remote Kit Installation
Installation Set Up
1.Open steel curtain (remove glass doors if applicable).
2.Remove two screws on log grate and remove log grate. (FIGURE 1)
3.Pull front edge of plastic ember bed grate up and forward until rear tab releases from the ledge located at the bottom of the mirror. (FIGURE 2)
! NOTE:Log set fits tightly
into firebox, some force may be
necessary to remove.
4.Locate and remove the two screws on the removable bracket. Remove the bracket. (FIGURE 3)
5.Locate and depress the mounting tabs on the plug connector to remove the ‘dummy plug’. (FIGURE 3)
! NOTE: Keep the ‘dummy plug
in a safe place. You will need it if
you decide to uninstall the remote
control to operate the fireplace
manually.
FIGURE 1
Screws
Manual Controls
FIGURE 2
Log
Emberbed
Back
Ledge
Rear
Tab
Side Section
Front
Edge
FIGURE 3
Removable
Bracket
Depress
Mounting
Tabs
Bracket and “Dummy Plug”
5
www.dimplex.com
Remote Kit Installation
Install Remote Control Receiver
1.Locate and insert the plug connector on the remote control bracket into plug connector on the fireplace. (FIGURE 4)
2.Place antenna under remote bracket.
3.Locate and install the two screws on the remote control bracket.
4.Replace the log by inserting front edge and pushing the back down until rear tab snaps under back ledge (FIGURE 2) and the logs are resting against mirror.
5.Replace log grate using two screws previously removed.
FIGURE 4
Plug
Connector
Remote Control Receiver
FIGURE 5
Manual Controls & Indicator Lights
6
Operation
Remote Control
The remote control has a range
of approximately 50ft. (15.25m). It
does not have to be pointed at the
fireplace and can pass through
most obstacles (including walls).
It is supplied with one of 2, 187
independent frequencies, in the
factory, to prevent interference
with other units.
Remote Control Initialization/
Reprogramming
Follow these steps for remote
control initialization and if
required, re-initialization:
1. Ensure that power is supplied
through main service panel.
2. Access the manual controls,
(remove the glass doors if
applicable) pull the right hand
steel curtain to the outside of
the unit. (FIGURE 5)
(Figure 6-A) for five (5)
seconds. The Level 1
Indicator Light
(Figure 6-D)
will then flash for 10 seconds.
7. Within the 10 seconds
press the ON button located
on the remote control
transmitter. (Figure 7) This
will synchronize the remote
control transmitter and
receiver.
Figure 6
A
D
E
B
C
F
3. Locate manual controls.
4. Move the 3-way switch to
“Remote”.
5. Activate the main power
switch, the red Level 1
Indicator Light will flash
(Figure 6-D)
.
6. Press and hold the On button
on the manual controls
7
www.dimplex.com
Operation
Remote Control Usage
The remote control operation can
be adjusted, depending on the
season and desired effects, by
toggling the main mode selector
switch built into the fireplace.
The position of the switch will
dictate the available functions that
the remote transmitter will cycle
through.
A. On Button
Pressing this button toggles
sequentially through the three
levels of the fireplace.
• Mode Selector Set at “O”:
Only Flame Effect at all 3
levels.
• Mode Selector Set at “--”:
Pressing once activates Level
1 - flame effect only, two and
three times activates Level 2 flame effect and Purifire™.
• Mode Selector Set at “=”:
Pressing once activates Level
1 - flame effect only, twice
activates Level 2 - flame
effect and Purifire™, three
times activates Level 3 flame effect, Purifire™ and
heat.
B. Off Button
Pressing this button at any time
will shut the unit off.
C.Manual Selection Switch
Switches the operation of the
fireplace between the different
modes of the fireplace:
• OFF (center): Makes the unit
inoperable.
• MANUAL (top): All functions
of the fireplace are controlled
by the On and Off buttons as
described above (A, B).
• REMOTE (bottom): All
functions of the fireplace are
controlled by the Remote
Control.
D. LED Indicators
Depicts which of the three (3)
levels the fireplace is currently
operating at: Level 1 2-
or Level 3 -
, Level
.
Figure 7
ON
Button
OFF
Button
Battery
Battery
Cover
Remote Control Transmitter
8
Maintenance
Battery Replacement
(Figure 7)
To replace the battery:
• Slide battery cover open on
the hand held transmitter.
• Correctly install one (1) 12
Volt (A23) battery in the battery holder.
• Close the battery cover.
Warranty
All Dimplex accessories are warranted against defects in workmanship
and materials for two years from date
of sale. This warranty does not apply
to damage from accident, misuse, or
alteration, nor where the connected
voltage is more that 5 % above the
nameplate voltage, nor to equipment improperly installed or wired or
maintained in violation of the instruction sheet. This limited warranty applies only to purchases made in any
province of Canada except for Yukon
Territory, Nunavut, or Northwest Territories or in any of the 50 States of the
USA (and the District of Columbia)
except for Hawaii and Alaska. This
limited warranty applies to the original
purchaser of the product only and is
not transferable. No other written or
oral warranty applies. No employee,
agent, dealer or other person is
authorized to give any warranties on
behalf of Dimplex. The customer shall
9
be responsible for all costs incurred
in the removal or reinstallation and
shipping of the product for repairs.
Within the limitations of this warranty,
inoperative units shall be returned
to the nearest Dimplex authorized
service center, and we shall repair or
replace, at our option, at no charge
to you with return freight paid be
Dimplex. It is agreed that such repair
or replacement is the exclusive remedy available from Dimplex and that
DIMPLEX IS NOT RESPONSIBLE
FOR DAMAGES OF ANY KIND,
INCLUDING INCIDENTAL AND
CONSEQUENTIAL DAMAGE. Some
States do not allow the exclusion or
limitation of consequential damages,
so the above exclusion or limitation
may not apply to you. This warranty
gives you specific legal rights and you
may also have other rights which vary
from state to state.
www.dimplex.com
Dimplex North America Limited
1367 Industrial Road
Cambridge ON
Canada N1R 7G8
© 2011 Dimplex North America Limited
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising